On 01/10/2015 03:15, David Garrido wrote:
Hmmmmmmmmmm……………..
I am having one heck of a time tracking this one down folks. I am starting to
entertain the idea that there is a possibility that somehow, me having this
things wide open is causing my difficulties here. Besides having the “Lid Open
and Disable switch,” I have that pulled up, is it possible that not having this
thing buttoned up all snug and tight could be a problem?
I have found myself in a spot where U41-11 is being sent low and causing a
fault indicator or high to be sent to U4-13. I cannot for the life of me
figure out why this is.
The differential Q104 is experiencing a difference of about 600mV from pin 5
and 2.
But I am wondering if that is one end of my loop and not the start?
Hmmmmmmmmmm……………..
Cheers,
David
Is something oscillating then?
_______________________________________________
volt-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts
and follow the instructions there.
