> to buy NEW bulbs from a reputable manufacturer who provides specs Any recommendations - I can't find a source in UK. I know Philips used to make them, but where I'd buy a few &deity only knows.
Thanks Dave -----Original Message----- From: volt-nuts [mailto:[email protected]] On Behalf Of Charles Steinmetz Sent: 17 November 2017 08:12 To: [email protected] Subject: Re: [volt-nuts] Neon bulbs for HP 3420B or 419A chopper circuit Pete wrote: > I've seen 95V but nothing as high as 125V. > The high brightness ones are usually 95V Neon gas at the typical pressures used in small lamps ignites somewhere near 200vDC. For this reason, commercial neon bulbs use a mixture of Neon and Argon, which lowers the strike voltage to the 70-100v region (again, depending on pressure). By this means, the original NE-2 was designed to strike at around 70v (DC or peak AC), while the NE-2H was designed to strike at around 120v (DC or peak AC). BUT: You never know what the heck you might get from many sources today. If you need a controlled strike voltage, the best bet is to buy NEW bulbs from a reputable manufacturer who provides specs. Most such bulbs have designations other than "NE-", although some are also identified with an original type on the datasheet. Note also that common neon lamps (e.g., NE-2) depend on some ambient light to promote ionization due to the "dark effect." This is particularly true for striking (many neons will not strike at all in total darkness), but affects continuing operation as well. For this reason, some variants had radioactive material added inside the envelope to promote ionization. These were often identified as "dark effect reduced" bulbs. The NE-2U, NE-2J, and NE-2H5 were among these. Originally, Thorium was used for this purpose, but before long Krypton 85 became the standard additive. Being a gas, it was much easier to incorporate. NOTE that the half-life of 85Kr is less than 11 years. This explains most failures of neons in chopper and LDR applications today. Radioactive enhancement is very important for chopper operation, since the chopper assembly necessarily keeps the lamps in total darkness. It also means that you probably do not want to buy/use surplus neon bulbs to repair choppers and LDRs (for two reasons -- you never know if they really had radioactive enhancement to begin with, and if they are old enough that you can be sure, they were made at least two half-lives ago and probably more like four, so they are all pooped out before you even install them). I managed to source some brand-new NE-2U equivalents in small quantities a few years ago, but I can't remember where I got them. (No problem if you want 10k of them -- several manufacturers will be happy to oblige.) Whatever you get, test them with a beta-sensitive detector to make sure they are reasonably active. The indication should be unmistakably strong -- if it's a case of, "Well, I think there may be some indication," they will not do. Best regards, Charles _______________________________________________ volt-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts and follow the instructions there. _______________________________________________ volt-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts and follow the instructions there.
