[VOPRadius] Question

[Suneel Jhangiani]

That is the way we do it as well. However your original post did say:   “I am not talking about routing a subnet. “   I’m not sure why you would want to assign customers multiple IP’s without giving them a small subnet. However, one option is to put a static route into your routers and allow them to statically assign the IP’s. This would of course have an impact on your router when there connection is down as it would be receiving ‘No route to host’ or ‘Host Down’ messages.       Regards,   Suneel Jhangiani Inter-Computer Technology Ltd.   Modus3 Bug Buster Co-MVP Willpower: The ability to eat only one salted peanut.     From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of [EMAIL PROTECTED] Sent: 08 October 2004 23:04 To: [EMAIL PROTECTED] Subject: [VOPRadius] Question   I got this figured out.  Not really that tough.  Just never did it before.....   Lets Say I am giving the customer the subnet 10.10.10.0/29   This is what I did....   Set Framed Address to 10.10.10.1 Set Framed Netmask to 255.255.255.248   Then I did two things to test.  On one account I set   Framed Route 10.10.10.0 255.255.255.248 10.10.10.1 1   For what ever reason this works for one account but does not work on another account.  I can't figure this one out as I am using the same hardware equipment to test.  Its just a different account.  Well none the less we have had to in the past use the Cisco AVPair attributes to do this and it works so this is what I used.   Cisco-AVPair "ip:route=10.10.10.0 255.255.255.248 10.10.10.1"   So, this lets the customer have a subnet at his WAN connection using PPPoE.   Tony D. Koehn Director of Networks Pixius Communications, LLC 316-219-8569 Amateur:  N0LVY     ----- Original Message ----- From: Charles Shaffer To: [EMAIL PROTECTED] Sent: Friday, October 08, 2004 1:46 PM Subject: [VOPRadius] Question   We tried this and Randy is right it did not work. Our work around was to reserve a hand full of IP that we assigned to the user. By reserve I mean we never assign these IP's to anyone. We would then hard code these IPs to the SonicWall's WAN interface.The Sonicwall would then pickup any broadcasts to those ip address. Of course this will only work if the device (ie: wireless, DSL) that makes the connection to the radius server is in bridge mode so the IP's go to the Sonicwall and not the device connected to the WAN port. Auth will still happen as normal only no framed address is handed off.   Good Luck   Charles -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]On Behalf Of [EMAIL PROTECTED] Sent: Thursday, October 07, 2004 11:47 AM To: [EMAIL PROTECTED] Subject: [VOPRadius] Question Hello,   Has anyone using Radius delegated multiple IP's to PPPoE user?   I am not talking about routing a subnet.    I need multiple IP's available to the customers WAN (Ethernet) interface specifically a sonic wall router.   Will Multiple Framed-Address attributes work on this?    Thanks for any suggestions.       Tony D. Koehn Director of Networks Pixius Communications, LLC 316-219-8569 Amateur:  N0LVY

<<image001.gif>>