-----Original Message-----
From: Frederick Sparber
BTW the 12 Volts is applied to each of the end plates only
the other 10 plates "float" just like the concentric cylinders
in the Joe Cell. the Plates are spaced with 1 cm sleeves
over the insulating rods passing through the enlarged
(two) holes in the plates.
<><><><><><>
If you read Bryan's comments below you will see that he's pulse width
modulating the 12 V to a 3.75 VRMS input. Also every other plate has
opposite polarity:
"Mach all thread rod is nutted to every other plate.
In other words two positive plates have a negative plate between them.
The plates alternate between positive and negative. The only reason
they don't touch each other is because of the larger hole drilled in
the plate wont allow the opposite polarity plate to make any contact
through the nut. Then I used magnet tape to keep the plates uniform.
And it seems to me that the magnet tape has benefits in the production
oh h2. The magnetic tape is not conductive. .. I hope this helps you
out. I really need to make a drawing, I know it is a little confusing
with the way I word thing.
If you need any more help just keep doing what you are doing and I will
help you all I can. "
He also uses MAGNETS . . . a direct violation of the Joe Cell concept.
This is a very dangerous device since the gas emitted is H2 and O2.
One little spark and . . .
Terry
___________________________________________________
Try the New Netscape Mail Today!
Virtually Spam-Free | More Storage | Import Your Contact List
http://mail.netscape.com
