--- Jones Beene <[EMAIL PROTECTED]> wrote: > The free-energy "regaugers" and magnet-heads have > been > hacking around the edges of this for some time, and > if they > cannot push any device into OU it may mean that they > have > missed one big (or actually quite tiny) detail. > Frequency. > What would be the minimum frequency for OU from a > "truncated > Lens Law" - that is, if we assume the Casimir is > optimum at > 2 nm and the effective speed of an EMF pulse is 2/3 > c ? BTW How low can the natural electrical vibration of an inductor go? An array 20 by 30 winds; ~ 4 inch by 6 inch winds of 600 winds connected as identically wound spirals from the outside in and ajacently layered as inside -out windings produces an extremely low oscillation some 30,000 hz, making the emf pulse itself near 1/13th c. This method of making "extra" internal capacity in a coil by its geometry reduces the natural resonant frequency of the coil. Monitoring of a pancake style coil with large width windings, resembling a spiralled one plate capacitor also shows significant lowerings of natural resonant frequencies. By using 4 layers the comparisons between a normal return wind method and the above method of turning one set of pancake coils backwards with respect to the other, but also reversing the enter and exits points of conduction show a reduction of 330,000 hz to 250,000 hz for a 200 ft length of such pancake coil windings. Since the edge of the insulated flattened wire is of a comparably smaller area between layers, then what the interior ajacent layerings provide for, we can only imagine the possible reductions available if the edges were also given appreciable internal capacity. In the simplest case of using square type insulated wire that could be layered in a diagonal manner, instead of the typical one dimensional layering manner of either horizontal or vertical, the increase of internal capacity for the one dimensional model to that of a two dimensional one to increase internal capacity can be shown to be greater then 6 fold. The first order magic square as a possible guide to coil numbered winding codes uses a diagonal layering method for its construction of successive winds. It may well turn out that the magic squares actually provide a code for constructing coils of maximum internal capacity. Particulary intriguing is the 2nd order square, first sensibly expressed as a 64 wind assembly. Here half of the winding routes can still be in the same position as a returned layered wind provides for, and only half of the routes need be changed to become a 8 sided magic square. If dual sets of diodes for current orientation paths could be placed at the 32 junctions that have the option of making changed winding routes, the array could function as a normal laterally wound array when the current is moving in one direction, but when the current reverses direction as occurs in AC, it would take the route of maximum internal capacity. This might be designed for consideration of making a parametric change of internal capacity, dependent on the frequency input of the generator, and we need not be concerned about the energy input normally involved by changing capacity by actual movements of plates through space itself. HDN
> we would also have to posit that the electron can > give up > angular momentum in a proper sized cavity (or > magnetic > domain) and get then that back from Casimir. > > Well it is faster than any solid state device is > likely to > produce for some time to come. The frequency is well > into > the EUV, but with line widths in semiconductors > already only > an order of magnitude "fatter" now, it won't be long > 'till > we find out - about 6 years before 2 nm is in mass > production ? depending on how one interprets Moore's > laws. > > But that geometry can be done now with electron beam > lithography... Depending on deep one's pockets > are... > > Jones > > > > > > > > > ===== Tesla Research Group; Pioneering the Applications of Interphasal Resonances http://groups.yahoo.com/group/teslafy/
