|
If it were only
that easy... 8^)
Specialized medical
product. Needs to be neat and clean. No heat scoring. No tip
bulge bigger than the diameter. I didn't believe it possible either until
I got a back stage tour.
Currently
doing semi-mass production with a couple of rube-Goldberg rigs.
Currently using a traditional TIG turned all the way down to 1 amp with an
alternate gas. Works reasonably well on 30ga tube with 0.003" walls, but
no way to turn it lower to do the thinner wall stuff with acceptable
results.
Just fishing for
ideas... wasn't sure if anyone had any experience with
micro-welding.
-john
-----Original Message-----
From: RC Macaulay [mailto:[EMAIL PROTECTED] Sent: Saturday, April 02, 2005 10:25 PM To: [email protected] Subject: Re: 1/2 amp Tig welder John Steck,
Way too low amps for what we use Tig's for.Can you fold and crimp and use
spot welder?. .002 wall is tissue paper.
Richard
|
<<Blank Bkgrd.gif>>
