Assuming that Naudin's Svetlana tubes are modified we need
to know what mods have been applied to the std. Svetlana
tube.
I believe the Moller specs say that the tube wall has a 1
mm sputtered W coating ... pretty thick for sputtering! I
wonder if Fred & Jones idea of using Pd, Rh, or Ru in some
combination would be as good as or better than the
sputtered W. Could any of these be plated to the wall
instead of sputtered to make fabrication easier.
In any case, I don't think we are even sure if it is wired
as a grid or a filament so I guess we just need to wait for
more information.
Ron
--On Wednesday, July 13, 2005 9:44 AM -0700 Jones Beene
<[EMAIL PROTECTED]> wrote:
Yes, we figured out the Svetlana connection a couple of
weeks ago on the atomic hydrgogen forum:
([EMAIL PROTECTED])
but it doesn't help much, since a modified hydrogen
filled-tube was ordered from the factory for this
experiment.
This filament is thoriated as well whereas the MAHG is
not (apparently from the spec sheet)
Jones
----- Original Message -----
From: "George Hathaway"
All,
Perhaps comparing Naudin's "tube" with an EIMAC
3CW20000A power triode may be instructive.
Frolov/Moller probably obtained the Russian equivalent
from St. Petersburg, where he lives, from Svetlana
(also in St. Pete's). See
http://www.g8wrb.org/data/Svetlana/pdf/3CW20000A7.pdf.
cheers - George Hathaway [EMAIL PROTECTED]
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/aH-gen/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
