Why don't just ask Parkhomov? 2014-12-31 9:23 GMT-02:00 Jack Cole <[email protected]>:
> It's very difficult to make this type of seal. When the cement is wet, > the hydrogen easily passes through. I use a dangerous gas detector as I > heat it up, but as yet, have not achieved a seal in experiments I've > tried. A lot of the cement requires heating to fully cure, but heating > causes hydrogen release. Your hydrogen escapes before the seal is made. > Maybe Parkhomov figured out how to do it. > > On Tue, Dec 30, 2014 at 10:36 PM, Bob Higgins <[email protected]> > wrote: > >> Based on analysis of Lugano and Parkhomov work, excess heat begins at >> about 950C. The MFMP dogbone core was measured to be over 1200C and no >> excess heat was found. The likely suspect is that the glue used to seal >> the reactor tube failed, allowing a leak of the H2 when the LiAlH4 >> decomposed. The experiment was shut down because going higher in >> temperature risked burnout of the dogbone heater coil and the excess heat >> should already have been seen at a lower temperature than the 1200C core >> temperature that was achieved. >> >> Ryan Hunt is going to try again. We will try to contact Parkhomov to ask >> what cement he used to seal his reactor. We are also looking at ways to >> test the seals that we make. >> >> Bob Higgins >> >> On Tue, Dec 30, 2014 at 8:35 PM, Jed Rothwell <[email protected]> >> wrote: >> >>> CB Sites <[email protected]> wrote: >>> >>> >>>> Wow, Replication fails. They had the "dog bone" so hot the steel >>>> stand holding it was white hot. But power in was equal to power out. No >>>> radiation. >>>> >>> >> >>> I have a hunch that was too hot. As the proverbial shaggy dog was too >>> shaggy, since we are using dog-related images here. >>> >>> - Jed >>> >>> >> > -- Daniel Rocha - RJ [email protected]
