https://www.facebook.com/MartinFleischmannMemorialProject

There might be something to this. Rossi placed ridges on the surface of the
Hot cat. This might have been an attempt to keep the Hot cat from
overheating through increased convective cooling. Rossi replication attemps
do not do this. Rossi would not have put these ridges on the surface of his
reactor for no good reason, The same increased cooling effect might be had
by cooling the reactor with a stream of air...fan cooling???

Using a variable speed fan could allow the experimenter to adjust the
degree of reactor cooling at will.

If this concept is valid, start a Hot cat test with a large amount of fan
cooling. Then the reaction might not start at 1200C. reduce the cooling in
stages until the reaction starts or the reactor melts down.

There is a great deal of consideration directed toward the ridges in the
Lagano report. From the Lagano test report...

"The reactor investigated on this occasion is outwardly quite different
from the ones used in the tests held in
the past years. Its external appearance is that of an alumina cylinder, 2
cm in diameter and 20 cm in length,
ending on both sides with two cylindrical alumina blocks (4 cm in diameter,
4 cm in length), non-detachable
from the body of the reactor, which henceforth will be referred to as
“caps”. An image of the reactor is given
in Figure1. Whereas the surface of the caps is smooth, the outer surface of
the body of the E-Cat is molded in
triangular ridges, 2.3 mm high and 3.2 mm wide at the base, covering the
entire surface and designed to
improve convective thermal exchange (cylinder diameter is calculated from
the bases of the ridges). In this
way, the current model of E-Cat is capable of attaining higher temperatures
than the earlier models, avoiding
internal melting, a previously fairly frequent occurrence [1]."

On Tue, May 26, 2015 at 1:12 PM, Peter Gluck <[email protected]> wrote:

> That's all:
>
> http://egooutpeters.blogspot.ro/2015/05/just-bit-info-for-may-26-2015.html
>
> More to come
>
> Peter
>
> --
> Dr. Peter Gluck
> Cluj, Romania
> http://egooutpeters.blogspot.com
>

Reply via email to