I would have to say that I agree that it must be possible since the system is working. When all the questions have been answered, it will become clear that the ECAT is real. Let's proceed to make it a viable design.
Dave -----Original Message----- From: peter.heckert <[email protected]> To: vortex-l <[email protected]> Sent: Wed, Nov 2, 2011 8:19 am Subject: [Vo]:Pipe diameter October 28 - new considerations Hi, I recalculated the pipe diameter needed for the 1MW plant. here is an important consideration that might have been missed by many: If all steam is condensed in the heatdissipator then we cannot assume air ressure at the other end of the pipe. n this case we must assume almost vacuum at the other side. If this is considered, we cannot use a steam pipe calculation for 1 bar. We must ssume 2 bar for the pressure difference. o Rossis statement, almost airpressure at this point, where the temperature was easured, could be true. lso a inner pipe diameter of about 8.5 cm (as I have measured) could work in his case. What do you think? Best, Peter
