Will be posting videos soon. Pioneering the Applications of Interphasal Resonances http://tech.groups.yahoo.com/group/teslafy/
--- On Mon, 7/23/12, David Jonsson <[email protected]> wrote: From: David Jonsson <[email protected]> Subject: [Vo]:Assymetric Maxwell stress tensors To: "vortex-l" <[email protected]> Date: Monday, July 23, 2012, 8:39 AM Are there any? It seems like a big shortcoming if there aren't any. David David Jonsson, Sweden, phone callto:+46703000370 Simply put when torsion is extreme enough, the vectors of normally perpendicular forces such as electricity and magnetism may become almost parallel;they undergo a kind of "distant parallelism" brought about by such extreme warping of space. Depending upon the amount of torsion, those vectors may not necessarily be perpendicular any more, but deviate slightly or greatly from such perpendicularity. pg 34/ Top Secret Torsion/Secrets of the Unified Field/ Joseph Farrell http://www.flickr.com/photos/harvich/4138926072/ 2009 Flux Capacitor Model E X B embodiments on separately phased resonances The Flux Capacitor is a spatially interacted electrical resonance. Resonance is the balancing of magnetic and electrical fields to contain equal field energies, where expression of this energy uses a coil for the magnetic flux, and a capacitor for the electric field energy. Normally these two different field energies exist in separate space, and because they oscillate they also exist in separate timings, whereby when one field is full the other is empty. The first premise of the flux capacitor is to Tconstruct a device whereby the vessels containing each energy expression themselves can exist in the same space at right angles, thereby creating a third reaction force to be obtained in the remaining third angle in space, here to be obtained by non-magnetic stainless steel rods protruding from the water capacitor. The aim here is to split the water molecule into oxygen and hydrogen fuel with the minimal amount of energy. Two 90 degree phased flux caps can share timings of field energy which is the goal of these endeavors, where the magnetic field from one resonance can be spatially interacted with a concurrent electric field from another separately phased resonance. http://www.flickr.com/photos/harvich/4138199465/ Axially Insulated Water Capacity in 465 hz Resonance This shows the effect of just the electric field resonating from the right coil at 2700 volts on a hand held grounded neon bulb. Notice that the end connection of the neon need not touch the central electrode of the water capacitor; the electric field energy passes through space itself. The input voltage is obtained from a mere 7 volts obtained from an AC car alternator rotating at a constant rpm to output 465 hz. To achieve the higher voltage output shown here a first stage of resonance is employed which multiplies the initial voltage 15 fold. These comprise two 500 ft wire spools of 14 gauge wire stacked in series; ~ 23 [email protected] ohms using 5 uf for 465 hz resonance. This first stage of series resonant rise is necessary to achieve any appreciable amperage through the secondary (interphasal) resonance to be formed into a flux capacitor principle, whereby this then increases the voltage almost another 17 fold. Each of the ending flux capacitor components are 180,000 ohms impedance at this frequency. The coils contain almost 8 miles of 23 gauge wire. An AC alternator is used to obtain the needed higher frequency to enable the resonances to spatially exist inside each other, which then involves special circumstances. Since every changing electric field also appears out of phase as a changing magnetic field according to the derivative of the electric field's rate of change in time, induced currents can be measured when a second coil is employed to surround the axial capacity employed as the first resonance to be engaged, which is shown here without the addition of the second resonance in the three phase triangle. It is found that the induced currents due to induction via spatially enclosed capacity inserted into the coils interior volume: that this value comprises 2/3 the amount of current registered when the interphasing is given its actual separately phased line connections. The second resonance uses an ordinary spatially separate plate plexiglass capacity. Essentially this second large coil in the 60 Henry range @ 840 ohms can be preliminarily tuned to the spatial influence of the initial resonance; however during this tuning where L2C2 has its capacity varied as a shorted loop formation, an amperage meter can be enclosed in this loop to find the point of highest power transfer. It this scenario cyclic or time varying amperages can be found. Apparently when a new resonant point is sought, the circuit may respond very slowly to the new point of resonant conduction. This makes noting the amperage quantities difficult when for cyclic cases where this amounts to measuring something that is not constant in time, but yet it may be cyclic in repetition of those changes. When L2C2 is tuned and disconnected, and then reconnected as a shorted loop to exhibit induction currents as a shorted loop: the initial resonance as the primary will decrease from 2.7 ma to 2.3 ma, but the secondary amperage will increase to 1.2 ma, where these values may take 30 seconds or so to assume themselves. http://www.flickr.com/photos/harvich/4609480576/ To fathom what the spatial changes to the circuit will do may not first be apparent. The axial water capacity will act just like an interior coil, in that it will induce currents and voltage by induction. The assymmetry may not be so evident, but each of the interior circuits will have different currents if the polarity of their inputs are reversed. What currents may go up by spatial interaction, do not go down by an equal amount, as found in single phase observations of mutual induction effects. In the above schematic it is noted that at a certain level the interphasal currents are in the ratio 2.7/1.7. Now if the voltage were to be increased to a larger level, this same initially observed ratio may not be evident. One side may work better then another again. Why this ratio change was evident at higher levels which caused the water to "pucker at the edges" and in a simpler version emit a hummed ringing sound is that now under the additional stress the electric field interacting with the magnetic field containing it, has become "less perdendicular" to its partner, and that component of the currents found on each phase is thereby lessened. Other examples of torsional effects by smaller components are evidenced in recent phase angle observations of both a krypton bulb discharge and the same voltage source powering a bipolar tesla coil. In these cases it becomes easy to show conditions for a 3D space time curvature made for both 1/5th bulb discharge and 1/4 time contraction for TC arcing. It stands to reason that since the mechanism for missing time is now understood to be a consequence of the tuned air core secondary transmission itself. It then forms a new R(int) value with respect to the load of the arcing distance. It is readily seen that the greatest efficiency is made with the greatest amount of secondary amperage circulation; and when a third pathway for load currents is made, this represents a diversion of current from the resonant LC loop. As that consequence the primary again consumes more current, and less efficiency.
