I have developed an interesting model of the Celani replication cell being researched by the MFMP group. It performs remarkably well in recent tests that I have conducted using USA data from the live data viewer and I was hoping that someone would help identify the best EU data for another thorough analysis. For some reason I have not located any recent measurements that I can be confident are supported by a trusted calibration run.
As I have mentioned before the model requires accurate coefficients that define the function of steady state power input versus outside glass temperature over a wide range of inputs. The parameters need to be calculated at the same pressure as the desired data to be analyzed. I also need to find at least one good associated input power increase transient of greater than 30 watts if possible to use to determine the time domain portion of my model. With the requested information in hand I am confident that my model will reveal whether or not there is excess power being generated and at what temperature it begins to appear. The model accurately generates a curve which follows the calibrated time domain response of the cell which can then be subtracted away from the actual measurements to yield a flat low noise line in the absence of excess power either being absorbed or generated. When a test experiment is conducted where the input power begins at one level and proceeds to a second higher level we effectively obtain a sweep response. If desired, I believe I could generate a linearization calculation on the difference data that would display the instantaneous power output versus power input. For this case I would transform the normal X time axis into the equivalent Power Input axis. In this type display, the equivalent power input would be shown as linear along the X axis. The Power Output would follow the zero line closely unless excess power is involved. I suspect that this view would make it easier to locate the power input levels associated with unusual power output behavior. Please post the EU data location and the associated calibration run for my extraction. The time and date of your selection from the live data feed of the MFMP would be the best choice. Thanks. Dave
