>From the report, an interesting explanation : The tests held in December 2012 and March 2013 are in fact subsequent to a previous attempt in November 2012 to make accurate measurements on a similar model of the
*E-Cat HT *on the same premises. In that experiment the device was destroyed in the course of the experimental run, when the steel cylinder containing the active charge overheated and melted. The partial data gathered before the failure, however, yielded interesting results which warranted further in-depth investigation in future tests. Although the run was not successful as far as obtaining complete data is concerned, it was fruitful in that it demonstrated a huge production of excess heat, which however could not be quantified.The device used had similar, but not identical, features to those of the *E-Cat HT *used in the December and March runs. On Mon, May 20, 2013 at 2:17 PM, Mark Gibbs <[email protected]> wrote: > > On Mon, May 20, 2013 at 12:46 PM, Arnaud Kodeck > <[email protected]>wrote: > >> Rossi has recently stated in JONP that local hot spots in its reactor >> were the main issue. If a spot come to a certain upper threshold, the >> reactor goes out of control. > > > Does anyone know what happens when Rossi's reactor goes out of control? > Does it melt down or just stop working? > > [mg] > > >
