Lewan April 19 : http://www.nyteknik.se/incoming/article3166567.ece/BINARY/Report+test+of+E-cat+19+April+2011.pdf
Not a clear knee ... maybe two linear slopes, then an exponential at the end Lewan April 28 : http://www.nyteknik.se/incoming/article3166569.ece/BINARY/Report+test+of+E-cat+28+April+2011.pdf Linear all the way to 100C Levi : December runs 1 (clear) 2 (not clear, data lost) http://lenr-canr.org/acrobat/LeviGreportonhe.pdf As it can be seen the system was turned on just around 16.55. After approx 30 minutes a kink can be observed in the (Y). Because input power (1120 W also checked via and clamp amperometer) was not modified (see fig. 5 later) this change of slope testify that the reactor was ignited. After a startup period approx 20 minutes long a second where the reactor power was almost constant taking the water to ≈75°C a second kink is found when the reactor fully ignites raising the measured temperature to 101.6 +/-0.1°C and transforming the water into steam. (That's all the reports which report a time-temperature profile) ----- Original Message ----- > Lewan Sep 7 : > http://www.nyteknik.se/incoming/article3264365.ece/BINARY/Report+E-cat+test+September+7+%28pdf%29 > > Near the end -- only starts plotting from 100C (output) -- linear to > 130C > >
