[vox-tech] ethernet card setup

David Siedband Sun, 22 Jun 2003 12:46:38 -0700

I'm installing an ethernet card in machine running Debian (woody)

here's the output from #lspci -v

01:0b.0 Ethernet controller: Lite-on Communications Inc LNE100TX (rev20)
        Subsystem: Kingston Technologies: Unknown device f002
        Flags: bus master, medium devsel, latency 64, IRQ 3
        I/O ports at d800 [size=256]
        Memory at fc9ec00 (32-bit, non-prefetchable) [size=256]
        Expansion ROM at fc980000 [disabled] [size=256]

(btw, none of the other devices listed had IRQ3)
This card uses the tulip.o driver, which I found in
/lib/modules/2.4.18-bf2.4/kernel/drivers/net/tulip/

from there I do
insmod tulip.o

and it then shows up in lsmod
tulip          37184     0      (unused)

I also added the following to the file in /etc/modutils/aliases (so it goes into /etc/modules.conf) alias eth0 tulip

I do
depmod -a

and try to initialize the eth0 adapter
ifup eth0
I get:
Ignoring unknown interface eth0=eth0

Any suggestions?

thanks

--
David

_______________________________________________
vox-tech mailing list
[EMAIL PROTECTED]
http://lists.lugod.org/mailman/listinfo/vox-tech

[vox-tech] ethernet card setup

Reply via email to