Thanks for any suggestions.
smime.p7s
Description: S/MIME Cryptographic Signature
_______________________________________________ Voyage-linux mailing list [email protected] http://list.voyage.hk/mailman/listinfo/voyage-linux
I have designed a circuit using PIC processors that will receive data
and send data to a serial port on my net4501 board. In my ignorance, I
wrote the code for the PIC processor to communicate at 2400 baud. To
initialize it, a couple commands get echo'ed to the serial port during
the bootup of the net4501 board (simple 'echo > /dev/ttyS0' stuff) , but
it defaults to 9600 baud. I tried setserial but it gives me an error
when using a baud rate less than 9600. I have already rewritten the
code for the PIC chip to use 9600 baud, but wanted to know if there was
a way to set the serial port to 2400 baud so as to not throw away the
PIC chips I've already programmed (you can only program these once....).
- [Voyage-linux] Serial port question Jake Vickers
- Re: [Voyage-linux] Serial port question Kerry Brown
