Apologies for the long post, but I thought the console output might
give a good indication of the problem here. Using a WRAP board. I
just installed the daily snapshot of 0.6 and noticed it was based on
etch. So, I changed sources.list to point to lenny and did `apt-get
update && apt-get dist-upgrade` . Now it hangs for several minutes
during bootup and seems to have major problems mounting the
filesystem.
Any clues?
-paker
------------------------------------------------
Booting 'voyage-linux-10Oct08'
root (hd0,0)
Filesystem type is ext2fs, partition type 0x83
kernel /vmlinuz root=LABEL=ROOT_FS console=ttyS0,38400n8
[Linux-bzImage, setup=0x2800, size=0x14d9d8]
initrd /initrd.img
[Linux-initrd @ 0x7dd4000, 0x21b158 bytes]
Linux version 2.6.23-486-voyage (2.6.23-2) ([EMAIL PROTECTED]) (gcc
version 4.1.2 20061115 (prerelease) (Debian 4.1.1-21)) #1 PR
EEMPT Wed May 21 15:31:49 GMT 2008
BIOS-provided physical RAM map:
BIOS-e820: 0000000000000000 - 00000000000a0000 (usable)
BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)
BIOS-e820: 0000000000100000 - 0000000008000000 (usable)
BIOS-e820: 00000000fff00000 - 0000000100000000 (reserved)
0MB HIGHMEM available.
128MB LOWMEM available.
Zone PFN ranges:
DMA 0 -> 4096
Normal 4096 -> 32768
HighMem 32768 -> 32768
Movable zone start PFN for each node
early_node_map[1] active PFN ranges
0: 0 -> 32768
DMI not present or invalid.
Allocating PCI resources starting at 10000000 (gap: 08000000:f7f00000)
Built 1 zonelists in Zone order. Total pages: 32512
Kernel command line: root=LABEL=ROOT_FS console=ttyS0,38400n8
No local APIC present or hardware disabled
Initializing CPU#0
PID hash table entries: 512 (order: 9, 2048 bytes)
Detected 233.286 MHz processor.
Console: colour dummy device 80x25
console [ttyS0] enabled
Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
Memory: 124284k/131072k available (1808k kernel code, 6244k reserved,
640k data, 164k init, 0k highmem)
virtual kernel memory layout:
fixmap : 0xfffac000 - 0xfffff000 ( 332 kB)
pkmap : 0xff800000 - 0xffc00000 (4096 kB)
vmalloc : 0xc8800000 - 0xff7fe000 ( 879 MB)
lowmem : 0xc0000000 - 0xc8000000 ( 128 MB)
.init : 0xc0368000 - 0xc0391000 ( 164 kB)
.data : 0xc02c4021 - 0xc036419c ( 640 kB)
.text : 0xc0100000 - 0xc02c4021 (1808 kB)
Checking if this processor honours the WP bit even in supervisor mode... Ok.
Calibrating delay using timer specific routine.. 467.37 BogoMIPS (lpj=233685)
Mount-cache hash table entries: 512
Compat vDSO mapped to ffffe000.
CPU: NSC Unknown stepping 01
Checking 'hlt' instruction... OK.
NET: Registered protocol family 16
PCI: PCI BIOS revision 2.10 entry at 0xfc47b, last bus=0
PCI: Using configuration type 1
Setting up standard PCI resources
SCSI subsystem initialized
PCI: Probing PCI hardware
PCI: Device 0000:00:12.5 not found by BIOS
Time: tsc clocksource has been installed.
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 4096 (order: 3, 32768 bytes)
TCP bind hash table entries: 4096 (order: 2, 16384 bytes)
TCP: Hash tables configured (established 4096 bind 4096)
TCP reno registered
checking if image is initramfs... it is
Freeing initrd memory: 2156k freed
io scheduler noop registered
io scheduler cfq registered (default)
Serial: 8250/16550 driver $Revision: 1.90 $ 2 ports, IRQ sharing enabled
serial8250: ttyS0 at I/O 0x3f8 (irq = 4) is a NS16550A
RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
SC1200: IDE controller at PCI slot 0000:00:12.2
SC1200: chipset revision 1
SC1200: not 100% native mode: will probe irqs later
ide0: BM-DMA at 0xfc00-0xfc07, BIOS settings: hda:pio, hdb:pio
ide1: BM-DMA at 0xfc08-0xfc0f, BIOS settings: hdc:pio, hdd:pio
Clocksource tsc unstable (delta = -232597083 ns)
Time: pit clocksource has been installed.
hda: CF 1GB, CFA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hda: max request size: 128KiB
hda: 2060352 sectors (1054 MB) w/0KiB Cache, CHS=2044/16/63
hda: hda1
i8042.c: No controller found.
mice: PS/2 mouse device common for all mice
padlock: VIA PadLock not detected.
padlock: VIA PadLock Hash Engine not detected.
TCP cubic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
Using IPI Shortcut mode
Freeing unused kernel memory: 164k freed
Loading, please wait...
Begin: Loading essential drivers ... done.
Begin: Running /scripts/init-premount ... natsemi dp8381x driver,
version 2.1, Sept 11, 2006
originally by Donald Becker <[EMAIL PROTECTED]>
2.4.x kernel port by Jeff Garzik, Tjeerd Mulder
natsemi eth0: NatSemi DP8381[56] at 0x80000000 (0000:00:0e.0),
00:0d:b9:06:46:f0, IRQ 10, port TP.
natsemi eth1: NatSemi DP8381[56] at 0x80040000 (0000:00:0f.0),
00:0d:b9:06:46:f1, IRQ 9, port TP.
natsemi eth2: NatSemi DP8381[56] at 0x80080000 (0000:00:10.0),
00:0d:b9:06:46:f2, IRQ 11, port TP.
done.
Begin: Mounting root file system ... Begin: Running /scripts/local-top ... done.
Begin: Running /scripts/local-premount ... done.
Begin: Running /scripts/local-bottom ... done.
done.
Begin: Running /scripts/init-bottom ... done.
INIT: version 2.86 booting
Starting the hotplug events dispatcher: udevdudevd version 125 started
.
Synthesizing the initial hotplug events...done.
Waiting for /dev to be fully populated...scx200: NatSemi SCx200 Driver
scx200: GPIO base 0xf400
scx200: Configuration Block base 0x9000
done.
Setting the system clock.
Activating swap...done.
EXT2-fs warning: mounting unchecked fs, running e2fsck is recommended
/etc/rcS.d/S11hwclock.sh: line 67: /etc/adjtime: No such file or directory
Setting the system clock.
Cleaning up ifupdown....
Loading kernel modules...SC1x00 Watchdog driver by Inprimis Technolgies.
wd1100.c: a few hacks by [EMAIL PROTECTED]
Registered led device: wrap:error
Registered led device: wrap:extra
done.
Loading device-mapper supportdevice-mapper: ioctl: 4.11.0-ioctl
(2006-10-12) initialised: [EMAIL PROTECTED]
.
Checking file systems...fsck 1.41.0 (10-Jul-2008)
done.
Setting kernel variables (/etc/sysctl.conf)...done.
Mounting local filesystems...failed.
Activating swapfile swap...done.
df: `/tmp': No such file or directory
df: no file systems processed
Setting up networking....
Configuring network interfaces...Internet Systems Consortium DHCP Client V3.1.1
Copyright 2004-2008 Internet Systems Consortium.
All rights reserved.
For info, please visit http://www.isc.org/sw/dhcp/
eth0: DSPCFG accepted after 0 usec.
eth0: link up.
Listening on LPF/eth0/00:0d:b9:06:46:f0
Sending on LPF/eth0/00:0d:b9:06:46:f0
Sending on Socket/fallback
DHCPREQUEST on eth0 to 255.255.255.255 port 67
DHCPACK from 192.168.254.254
bound to 192.168.254.3 -- renewal in 502641 seconds.
if-up.d/mountnfs[eth0]: lock /var/run/network/mountnfs exist, not
mounting failed!
NET: Registered protocol family 10
lo: Disabled Privacy Extensions
done.
Starting portmap daemon....
/etc/rcS.d/S55bootmisc.sh: line 29: /var/run/utmp: No such file or directory
INIT: Entering runlevel: 2
Starting watchdog keepalive daemon: wd_keepalive.
Starting system log daemon....
Starting kernel log daemon... ****************** very very long pause
here (20 -30 minutes?) ********************* failed!
Starting DNS forwarder and DHCP server: dnsmasq
dnsmasq: failed to open pidfile /var/run/dnsmasq.pid: No such file or directory
failed (warning).
failed!
mkdir: cannot create directory `/var/run/sshd': No such file or directory
Starting portmap daemon....
mkdir: cannot create directory `/var/run': File exists
chown: cannot access `/var/run/clamav': No such file or directory
Starting ClamAV virus database updater: freshclamERROR: Can't open
/var/log/clamav/freshclam.log in append mode (check permissi
ons!).
ERROR: Problem with internal logger (UpdateLogFile =
/var/log/clamav/freshclam.log).
failed!
Starting advanced IEEE 802.11 management: disabled via /etc/default/hostapd.
Not starting internet superserver: no services enabled.
Starting PPTP Daemon: pptpd.
DansGuardian has not been configured!
Please edit /etc/dansguardian/dansguardian.conf manually then rerun
this script.
Starting periodic command scheduler: crond/usr/sbin/cron: can't open
or create /var/run/crond.pid: No such file or directory
failed!
Stopping watchdog keepalive daemon:
Starting watchdog daemon: watchdog error:
Cannot create directory /var/log/watchdog
Remounting / as read-write ... Done.
Removing /etc/nologin ... Done.
Remounting / as read-only ... mount: / is busy
voyage login:
_______________________________________________
Voyage-linux mailing list
Voyage-linux@list.voyage.hk
http://list.voyage.hk/mailman/listinfo/voyage-linux
