Hi Andrey,
I try to repeat your cast but no avail.
See my dmesg grep below:
=========================================
voyage:~# dmesg|egrep "ftdi|tty"
[ 0.000000] Kernel command line:
root=UUID=92596085-f0a4-42cf-84ba-d9a03e8e4c00 ro console=ttyS0,38400n8
[ 0.000999] console [ttyS0] enabled
[ 2.198492] serial8250: ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A
[ 14.833820] ftdi_sio 2-1:1.0: FTDI USB Serial Device converter detected
[ 14.834820] ftdi_sio: Detected FT232RL
[ 14.835820] usb 2-1: FTDI USB Serial Device converter now attached to
ttyUSB0
[ 14.836820] usbcore: registered new interface driver ftdi_sio
[ 14.837820] ftdi_sio: v1.4.3:USB FTDI Serial Converters Driver
voyage:~# ls -la /dev/ttyUSB0
crw-rw---- 1 root dialout 188, 0 Jan 1 2000 /dev/ttyUSB0
=========================================
Regards,
Punky
Andrey Kaplun wrote:
Hello
Someone knows why if I start Voyage of with pluged USB-device (FTDI Of
serial converter) the linux message:
"ftdi_sio ttyUSB0: FTDI USB Serial Device converter now disconnected
from ttyUSB0
ftdi_sio 2-2.4:1.0: device disconnected".
And /dev/ttyUSB0 not of created. But if I reconnect device (the of
voyage is of already of loaded) the /dev/ttyUSB0 is created successfully.
How to make so that during the reloading it would not be necessary to
disconnect and connected USB-devices manualy?
Best Regards,
Andrey Kaplun
------------------------------------------------------------------------
_______________________________________________
Voyage-linux mailing list
[email protected]
http://list.voyage.hk/mailman/listinfo/voyage-linux
_______________________________________________
Voyage-linux mailing list
[email protected]
http://list.voyage.hk/mailman/listinfo/voyage-linux
