Hi.
I do have a lot of experience with PIC microcontrollers, but I havn't found
info on how he LIRC communicates using RX,TX signals instead of the DCD,RTS
etc.
Also, I havn't found any good IR Trancievers using PIC on the web either
(Recievers can be found but o transmitters so far).
mvh
P.
----- Original Message -----
From: "Nick L." <[email protected]>
To: "Patrik Rostedt" <[email protected]>
Cc: <[email protected]>
Sent: Wednesday, April 27, 2011 4:31 PM
Subject: Re: [Voyage-linux] MDP + LIRC
2011/4/27 Patrik Rostedt <[email protected]>:
Hi.
I like to set up a Voyage setup using LIRC and a homebrew IR
transmitter/receiver and noticed that the Voyage MDP is shipped with LIRC
included in the package, although I cannot find any notes on what hardware
are supported, or if it supports transmission of IR signals as well.
I do have an Alix 3d3 board running Voyage today, but need advice on what
hardware could be used with LIRC, Voyage (MDP) and Alix – any advice?
Do you have any experience using micro-controllers? The advice I got
from Pascal (designer of PC Engines boards) was to you a small microc
ontroller connected to the TTL com port todo the IR decoding.
A little Googling and I found this: http://www.foxharp.boston.ma.us/avrlirc/
I am going to got this route since I don't want anything on my USB
competing with my USB DAC. Also, no recompiling of modules every time
a new kernel comes out.
I just recently ordered a 20 pin ZIF to program the ATTiny 2313. Might
be a while to get the project completed.
_______________________________________________
Voyage-linux mailing list
[email protected]
http://list.voyage.hk/mailman/listinfo/voyage-linux
