Hi,
you can also setup a proxy on your node1, maybe polipo is a good choice.
Polipo is well documented, may be the dox are a good starting point for
further explorations.
HtH
On 09/09/2011 05:44 PM, Sebastian Robitzsch wrote:
the answer is NAT on node1 including the corresponding routes set up on
node 1 between eth0 and wlan0/ath0. However, I recommend using node 1 as
the AP because otherwise you need to make sure that all the traffic goes
directly to the client (node 1) instead of getting routed through the AP
(node 2).
An easy to follow howto for NAT can be found here:
http://seronline.de/?p=53
Cheers,
Sebastian
On Fri, 2011-09-09 at 14:26 +0100, [email protected] wrote:
Hi,
I have a WLAN network of three devices {node1, node2, node3}, static IP are
192.168.2.1, 192.168.2.2, 192.168.2.3.
The access point is node2 so node1 and node3 are stations for node2.
Node1 is the only one that has access to internet by eth0. eth0 at node1 has a
static ip.
Node2 and node3 can connect to node1.
Node 1 can connect to internet.
Node2 and node3 can NOT connect to internet.
How should I configure node2 and node3 in order to reach internet?
Many thanks
Davide
_______________________________________________
Voyage-linux mailing list
[email protected]
http://list.voyage.hk/mailman/listinfo/voyage-linux
_______________________________________________
Voyage-linux mailing list
[email protected]
http://list.voyage.hk/mailman/listinfo/voyage-linux
