Den 15.03.2010 18:22, skrev Luke LeBoeuf: > Matt, > Thanks again. That worked! the tunnel is now established, but now I > can not seem to get to any device on the VPN network. The tunnel shows > up, the firewall logs show a good connection, but I can not navigate to > any devices on the gateway side (i.e. rdp, netbios, ssh, etc.) Any > ideas? Do I need to add additional policies that allow all traffic to > certain devices? I thought the vpn policy would have taken care of that > ( Source = DialupVPN to Internal-net (192.168.1.0/24) any service, none > (all) application, action=tunnel, tunnel=vpnclient_tunnel). The VPN rule > is at the top of the list for the inbound (untrust to trust) rules, is > that acceptable?
If your vpn-tunnel is coming in on an interface on your Untrust virtual router, you need to either enable "Auto Export Route to Untrust-VR" on your Trust-VR, or manually set up destination routing in your Untrust-VR. If your tunnel is coming in on the same virtual router as the network you are trying to reach, I don't know what's wrong, but you can debug it with debug flow basic. -Stian _______________________________________________ vpn-help mailing list [email protected] http://lists.shrew.net/mailman/listinfo/vpn-help
