On 2/6/2012 11:55 PM, Mike Pacifico wrote:
Hello,
Just installed a watchguard XTM 510 4.2.1. Exported the the .vpn,
imported the config file into the VPN client. According the the
watchguard, I am authenticated as an client, or am I? No packets are
being moved.
I apologize in advance if I'm overlooking the obvious, but it's been a
very long day.
...
12/02/06 21:38:35 DB : config resend event scheduled ( ref count = 2 )
12/02/06 21:38:35 ii : building config attribute list
12/02/06 21:38:35 ii : - IP4 Address
12/02/06 21:38:35 ii : - Address Expiry
12/02/06 21:38:35 ii : - IP4 Netamask
12/02/06 21:38:35 ii : - IP4 DNS Server
12/02/06 21:38:35 ii : - IP4 WINS Server
12/02/06 21:38:35 ii : - IP4 Subnet
12/02/06 21:38:35 == : new config iv ( 8 bytes )
12/02/06 21:38:35 ii : sending config pull request
12/02/06 21:38:35 >> : hash payload
12/02/06 21:38:35 >> : attribute payload
12/02/06 21:38:35 == : new configure hash ( 20 bytes )
12/02/06 21:38:35 >= : cookies f88412956c4b60da:93e25c78b27cfdea
12/02/06 21:38:35 >= : message 6a213b7c
12/02/06 21:38:35 >= : encrypt iv ( 8 bytes )
12/02/06 21:38:35 == : encrypt packet ( 84 bytes )
12/02/06 21:38:35 == : stored iv ( 8 bytes )
12/02/06 21:38:35 DB : config resend event canceled ( ref count = 1 )
12/02/06 21:38:35 -> : send NAT-T:IKE packet 192.168.1.6:4500
It would appear that the client is requesting modecfg information but
doesn't receive a response from the gateway. This would typically point
to a configuration mismatch between the client and the server. You say
you exported the .vpn file. Was that from another working client?
-Matthew
_______________________________________________
vpn-help mailing list
[email protected]
http://lists.shrew.net/mailman/listinfo/vpn-help
