Thank you for your reply. I have checked my config, but DPD was not
enabled. I cannot find any keepalive/heartbeat statements in my config
(NAT-keepalive is off). The problem remains the same, also with other
users at different remote locations. I feel i have tried all possible
options, but nothing seems to work. Are there any other possible options
i could try?
Kind regards,
Jeroen Hermans
On 12-4-2012 4:31, Kevin VPN wrote:
On 04/03/2012 04:09 PM, Jeroen J.A.W. Hermans wrote:
I have a problem i have been working on a few weeks now and i don't seem
to be able to get Shrew to work nicely with my Juniper SRX210. Setting
up a VPN to the SRX is not a problem. Phase 1 and 2 are completed
succesfully. I am able to ping to the other netwerk without any
problems, but after about 6 minutes Shrew disconnects (see tracedump
under this mail). I am using a Juniper SRX210 running JunOS 11.1R1.10
and Shrew VPN 2.2.0. I am using a cabled network and i am behind a NAT
router.
Hi Jeroen,
I would look at the Dead Peer Detection (DPD) or Heartbeat/Keepalive
settings, they often have a timeout of 300 seconds (5 minutes). Try
turning DPD or Heartbeat off to see if that changes the problem.
_______________________________________________
vpn-help mailing list
[email protected]
http://lists.shrew.net/mailman/listinfo/vpn-help
