Hi there, wondering if anyone has had any similar issue, where Shrew will connect to a PIX515E from only some locations but the cisco client works from all.
Any help or suggestions are greatly appreciated. Thanks in advance! Scott Smith Telizon Inc. From: [email protected] [mailto:[email protected]] On Behalf Of Scott Smith Sent: Thursday, December 20, 2012 9:12 PM To: [email protected] Subject: [vpn-help] client connects from some locations, not my house! Using the same machine, installation & VPN connection profile I am able to connect to a CISCO PIX 515E from some locations (public library, remote office, co-workers house), but not from my own home and not from my bosses place. The machine I'm using is a Windows 7 64-bit running Shrew 2.2.0 (2.1.7 had the exact same issue). My home internet connection is not stellar (It's rural wireless, up to 3Mbps down/768 kbps up) but works well enough for the Cisco VPN client to connect when running in XP mode. Could the connection speed be an issue for Shrew even though Cisco works? I've checked the connection MTU but didn't locate a problem there. >From my home, the connection attempt appears as follows: config loaded for site '<IP ADDRESS>' attached to key daemon ... peer configured iskamp proposal configured esp proposal configured client configured local id configured remote id configured pre-shared key configured bringing up tunnel ... negotiation timout occurred tunnel disabled detached from key daemon Thanks in advance for any help anyone can provide with this! Cheers, Scott
_______________________________________________ vpn-help mailing list [email protected] http://lists.shrew.net/mailman/listinfo/vpn-help
