Hi,

It should be “snat add static mapping local 172.16.1.3 6303 external 4.4.4.4 
3606” not “snat add static mapping local0 172.16.1.3 6303 external 4.4.4.4 
3606”. You also need to run first “snat add addresses 192.168.15.14” if you are 
not running “static mapping only” mode (you can set this in snat section in 
startup config).

Regards,
Matus
From: vpp-dev-boun...@lists.fd.io [mailto:vpp-dev-boun...@lists.fd.io] On 
Behalf Of liyu...@telincn.com
Sent: Tuesday, October 11, 2016 10:30 AM
To: vpp-dev <vpp-dev@lists.fd.io>
Subject: [vpp-dev] Some problems about VPP/snat


Hi
Bother you, ask you a question.
I use the CLI command test VPP/snat plug-in
Find other three commands can be executed, but the add static mapping can't 
identify.Could you tell me the need what configuration?


[cid:image002.jpg@01D2248D.86861AD0]
[cid:image004.jpg@01D2248D.86861AD0]

________________________________
liyu...@telincn.com<mailto:liyu...@telincn.com>
_______________________________________________
vpp-dev mailing list
vpp-dev@lists.fd.io
https://lists.fd.io/mailman/listinfo/vpp-dev
  • [vpp-dev] Some... liyu...@telincn.com
    • [vpp-dev]... liyu...@telincn.com
    • [vpp-dev]... liyu...@telincn.com
      • Re: [... Matus Fabian -X (matfabia - PANTHEON TECHNOLOGIES at Cisco)
    • [vpp-dev]... liyu...@telincn.com
      • Re: [... Matus Fabian -X (matfabia - PANTHEON TECHNOLOGIES at Cisco)
        • R... yug...@telincn.com
          • ... Matus Fabian -X (matfabia - PANTHEON TECHNOLOGIES at Cisco)
            • ... yug...@telincn.com
              • ... Matus Fabian -X (matfabia - PANTHEON TECHNOLOGIES at Cisco)

Reply via email to