Hi,
I am trying to connect a PCI interface by following the instructions on the
wiki on a Centos 7 system.
I built and installed VPP and was able to setup the interface
GigabitEthernet1/0/1 and add the ip address.
Unfortunately all messages are being dropped. The following is a capture of my
ping:
00:43:16:995516: dpdk-input
GigabitEthernet1/0/1 rx queue 0
buffer 0xccda79: current data 14, length 84, free-list 0, clone-count 0,
totlen-nifb 0, trace 0x3
PKT MBUF: port 0, nb_segs 1, pkt_len 98
buf_len 2176, data_len 98, ol_flags 0x180, data_off 128, phys_addr 0x8d65d40
packet_type 0x11
Packet Offload Flags
PKT_RX_IP_CKSUM_GOOD (0x0080) IP cksum of RX pkt. is valid
PKT_RX_L4_CKSUM_GOOD (0x0100) L4 cksum of RX pkt. is valid
Packet Types
RTE_PTYPE_L2_ETHER (0x0001) Ethernet packet
RTE_PTYPE_L3_IPV4 (0x0010) IPv4 packet without extension headers
IP4: b8:38:61:64:91:bf -> 2c:5a:0f:ff:c1:5b
ICMP: 10.30.3.2 -> 10.30.5.2
tos 0x00, ttl 63, length 84, checksum 0x7106
fragment id 0xae63, flags DONT_FRAGMENT
ICMP echo_request checksum 0x9b75
00:43:16:995524: ip4-input-no-checksum
ICMP: 10.30.3.2 -> 10.30.5.2
tos 0x00, ttl 63, length 84, checksum 0x7106
fragment id 0xae63, flags DONT_FRAGMENT
ICMP echo_request checksum 0x9b75
00:43:16:995530: ip4-lookup
fib 0 dpo-idx 6 flow hash: 0x00000000
ICMP: 10.30.3.2 -> 10.30.5.2
tos 0x00, ttl 63, length 84, checksum 0x7106
fragment id 0xae63, flags DONT_FRAGMENT
ICMP echo_request checksum 0x9b75
00:43:16:995542: ip4-local
ICMP: 10.30.3.2 -> 10.30.5.2
tos 0x00, ttl 63, length 84, checksum 0x7106
fragment id 0xae63, flags DONT_FRAGMENT
ICMP echo_request checksum 0x9b75
00:43:16:995546: error-drop
ip4-input: ip4 source lookup miss
I suspect that this is because I was unable to run the modprobe igb_uio as
indicated in the wiki.
Any ideas on how to set this up to work correctly on a Centos machine?
Thanks,
Guy
_______________________________________________
vpp-dev mailing list
vpp-dev@lists.fd.io
https://lists.fd.io/mailman/listinfo/vpp-dev
