Hi,
I tried to install vserver on Gentoo using the howto on the Gentoo website as
well as a document in the vserver wiki. When I now try to start my vserver I
get the following error messages:
# vserver -v gentoo-template start
/usr/sbin/vserver: line 66: test: -v: unary operator expected
/usr/sbin/vserver: line 543: ip: command not found
/usr/sbin/vserver: line 545: ip: command not found
[ ... ]
This seems to me that the -v switch is broken. The parameter --verbose seems
to be ok:
vserver --verbose gentoo-template start
/usr/sbin/vserver: line 543: ip: command not found
/usr/sbin/vserver: line 545: ip: command not found
ipv4root is now 10.0.5.1
ipv4root is now 10.0.5.1
New security context is 49157
* Setting system clock to hardware clock [UTC]...
* Failed to set system clock to hardware clock
[ !! ]
* Setting DNS domainname to wschalk.org...
[ ok ]
* ERROR: Problem starting needed services.
* "bootmisc" was not started.
* ERROR: Problem starting needed services.
* "syslog-ng" was not started.
* Bringing eth0 up (10.0.5.1)...
SIOCSIFADDR: Permission denied
SIOCSIFFLAGS: Permission denied
SIOCSIFBRDADDR: Permission denied
SIOCSIFFLAGS: Permission denied
SIOCSIFNETMASK: Permission denied
[ !! ]
* ERROR: Problem starting needed services.
* "sshd" was not started.
* ERROR: Problem starting needed services.
* "vixie-cron" was not started.
Where can I find the configuration file vserver uses? I need to add
capabilities to this vserver in order to make it work (sorry I am a complete
newbie). I created my vserver as follows:
# vserver gentoo-template build -m skeleton --hostname gentoo-template --flags
lock,nproc --initstyle gentoo --interface gentoo=eth0:10.0.5.1/24
Any ideas?
Thanks a lot.
Bye,
Werner.
_______________________________________________
Vserver mailing list
[email protected]
http://list.linux-vserver.org/mailman/listinfo/vserver
