On Sat, Oct 22, 2005 at 09:46:46PM +0200, Guenther Fuchs wrote: > Hi there, > > have a bit of problem here with setting up the proper routing for a > special environment / requirement: > > I've here a dual-homed system which mainly should only be available to > an internal net. Base host therefore hase no external IP (and shall > not), all requests to external shall be routed through an (extra) NAT > gateway. > > So far no problem, setting up all hosts only on eth1 and having a > default gw on the base for this eth1 default route works fine. > > Now the prob: There should be set up _one_ host with also internal > _and_ external IP (on eth0) which should externally use a different gw > and also which should not change anything on the base setup. But if I > activate _any_ external IP on eth0 the (previous) default route for > eth1 is nomore used but guests (only having eth1 activated!) try to > connect direct through this eth0 ip which they naturally can't use so > traffic stops completely 8-( > > Any idea's/hint's?
http://linux-vserver.org/Documentation (section archived knowledge) http://archives.linux-vserver.org/200311/0470.html best, Herbert > -- > regards, > > Guenther Fuchs > > _______________________________________________ > Vserver mailing list > [email protected] > http://list.linux-vserver.org/mailman/listinfo/vserver _______________________________________________ Vserver mailing list [email protected] http://list.linux-vserver.org/mailman/listinfo/vserver
