Heya, On Mon, 2006-08-14 at 06:11 +0200, Herbert Poetzl wrote: > > > > I tried to run 2.6.17.7 with the 2.0.2-rc28 patch from > > vserver.13thfloor.at/Experimental but it oopsed when starting init > > (and it didn't go on anymore after that), 2.6.17.6 with the 2.0.2-rc26 > > patch worked fine (which was for 2.6.17.4 but only makefile had to be > > adjusted). > > hmm? would be nice to get a view on the oops > (i.e. either capture it with a serial console, or > if that is not possible, take a picture or transcribe > the text) > > > Perhaps it's something obvious... I'm doing this inside vmware. > > could be, we won't know without the oops :)
I figured, but at that moment I was on holidays - couldn't resist to set something up on a virtual machine I was offered though ;) I'm back now, here's the oops: http://magic.powersource.cx/~tom/vserver-oops.png I don't know if there was something above it, it happens quite fast - if you can tell me how to get a larger console (80x50 or so) I could try again... It's an oops, not a panic, but as you can see Init "starts" but doesn't do anything anymore after that. It's plain 2.6.17.7 patched with the available 2.6.17.7 patch. > > Kernel config available on request, perhaps even the kernel log (if > > needed, but then I'll need to reboot into the new/old kernel) - more > > info from sid3windr @ #vserver as well... > > okay, will look into it then ... Thanks, Tom _______________________________________________ Vserver mailing list Vserver@list.linux-vserver.org http://list.linux-vserver.org/mailman/listinfo/vserver
