I had the same problem as original poster and in private email discovered we
had tried the same steps. For me the newvserver failure occurred both on CD
(7.3 & 8.0 & 8.1beta) and /. I tried perhaps 10 times, with both
vserver-admin .21 & .22. It always worked when trying to clone an existing
vserver. I redirected standard error and saw some messages but I didn't
record them or try to debug the problem further since "vserver xxx build"
worked fine.
-----Original Message-----
From: Jacques Gelinas [SMTP:[EMAIL PROTECTED]]
Sent: Tuesday, February 04, 2003 7:47 PM
To: [EMAIL PROTECTED]
Subject: re: [vserver] newvserver
On Fri, 31 Jan 2003 18:44:05 -0500, Mehmet Avcioglu wrote
>
> Is it just me or is the newvserver script doesn't work at all?
>
> Whatever I tried, it either gives an error (to fast for me to
read) and
> exits or gives an error and exits after copying couple
directories.
>
> I searched the mailing list for similar problems and did not come
up
> with any..
Can you provide a little more information. You tried to setup a
vserver
by using what ? A redhat CD ? Cloning the / ?
---------------------------------------------------------
Jacques Gelinas <[EMAIL PROTECTED]>
vserver: run general purpose virtual servers on one box, full speed!
http://www.solucorp.qc.ca/miscprj/s_context.hc
