Please find /etc/modules.conf below... ============================================== alias eth0 e100 alias usb-controller usb-uhci alias sound-slot-0 es1370 post-install sound-slot-0 /bin/aumix-minimal -f /etc/.aumixrc -L >/dev/null 2>&1 || : pre-remove sound-slot-0 /bin/aumix-minimal -f /etc/.aumixrc -S >/dev/null 2>&1 || : ==============================================
Thanks, Joseph From: Mike Savage <[EMAIL PROTECTED]> on 06/06/2003 21:40 Please respond to [EMAIL PROTECTED] To: "'[EMAIL PROTECTED]'" <[EMAIL PROTECTED]> cc: Subject: RE: Re[2]: [vserver] eth0 fail to start What does the contents of your /etc/modules.conf file look like? -----Original Message----- From: Joseph S Chung [mailto:[EMAIL PROTECTED] Sent: Thursday, June 05, 2003 11:03 PM To: [EMAIL PROTECTED] Subject: Re[2]: [vserver] eth0 fail to start I do not see eth0 with ifconfig command. It is not working. I did not complie the kernel after downloading from web. How can I get the .config file. I do not have one in /usr/src/linux-2.4. By the way, I am using RedHat 9.0. Thanks. Joseph From: Guillaume Plessis <[EMAIL PROTECTED]> on 05/06/2003 18:07 Please respond to [EMAIL PROTECTED] To: [EMAIL PROTECTED] cc: Subject: Re: [vserver] eth0 fail to start Joseph S Chung wrote: > I am not sure. It is Intel 82557/8/9 Ethernet Pro 100. How can I > check? Thanks, Joseph There are many way do to this : 1/ Check that the following options are marked "=y" or "=m" in the .config file used during your kernel compilation: CONFIG_NET_PCI CONFIG_EEPRO100 in case of "=m", you ahve to check that the modules is loaded during the system boot 2/ check that you get eth0 when you lauch "ifconfig -a" 3/ ... Best regards Gui
