I would have TWTC force their side to 100 Full, and you do the same
on yours. Collisions, 99% of the time, only occur as a result of a
duplex mismatch.
------------------
Aubrey Wells
Senior Engineer
Shelton | Johns Technology Group
404.478.2790
www.sheltonjohns.com
On Sep 20, 2007, at 7:10 PM, Jeff wrote:
On the 7206 the interfaces are FastEthernet interfaces
I did try each one from auto to force, etc and did not seem to make
any difference
But I was not trying to much. Till I asked some pointers
Maybe its something I will have to have Timewarner match the switch
to my ethernet card, no idea for sure
Jeff
From: Allan Leinwand [mailto:[EMAIL PROTECTED]
To: 'Jeff' [mailto:[EMAIL PROTECTED], vyatta-
[EMAIL PROTECTED], vyatta-users@mailman.vyatta.com
Sent: Thu, 20 Sep 2007 17:36:42 -0400
Subject: RE: [Vyatta-users] Errors On Outgoing Ethernet Interface
Hi Jeff,
I'd guess that you're having an issue with the auto negotiation
of speed and/or duplex on that interface. You can set these
commands as follows:
vyatta# set interfaces ethernet eth0 duplex ?
Possible completions:
auto Set duplex auto-negotiation mode
full Set full duplex mode
half Set half duplex mode
I'd make sure you're set for auto on both speed and duplex and
if that does not work I'd try to force the interface into a setting
that you know will work. "show interfaces" on your 7206 can show
you the current settings.
Take care,
allan
From: [EMAIL PROTECTED] [mailto:vyatta-users-
[EMAIL PROTECTED] On Behalf Of Jeff
Sent: Thursday, September 20, 2007 2:23 PM
To: vyatta-users@mailman.vyatta.com; vyatta-users@mailman.vyatta.com
Subject: [Vyatta-users] Errors On Outgoing Ethernet Interface
I finally got to do a test run on vyatta today for the 1st run.
I have two ethernet interfaces setup one for lan the other for the
wan connected to TimeWarner
I unplugged my 7206vxr cisco
And plugged in the two ethernet interfaces from it into my vyatta box
At any rate all seemed fine I could ping in and out, my ipaddresses
asgned were visable.
All looked great, but then I logged into the vyatta web interface,
and seen that the ethernet interface going to the wan
to tme warner switch was poplulting errors in the amount of 5
errors at a time every so many seconds
At anyrate I viewed the interface and seen it was showing colisions.
The ethernet interface to the local lan had no errors at all.
So after a little more runtime I plugged back into the cisco, (No
errors) and all was totally fine again.
Any ideas what may be causing these errors?
I have built the vyatta on a Vision 1GHz Pent 3 with 1 gig ram and
80 gig harddrive (basically overkill)
Anyway the two ethernet cards are built into the motherboard..
Jeff
_______________________________________________
Vyatta-users mailing list
Vyatta-users@mailman.vyatta.com
http://mailman.vyatta.com/mailman/listinfo/vyatta-users
_______________________________________________
Vyatta-users mailing list
Vyatta-users@mailman.vyatta.com
http://mailman.vyatta.com/mailman/listinfo/vyatta-users
