Thanks for the informations.
@@ Luc
Are you getting a dynamic ot static IP from your ISP?
Do you use loop_on_init = True in your conf file?
Thanks again
Michael
Am Montag, 10. Juli 2017 05:47:09 UTC+7 schrieb Tom Keffer:
>
> Michael,
>
> loop_on_init only affects how an error in the driver is handled on startup.
>
> Normally, if an error is encountering when weewx is starting up
> ("initializing"), the program exits. The assumption is that the user has a
> configuration problem, so there is no point in trying the same thing
> over-and-over again.
>
> However, if loop_on_init is set to true, then weewx will restart from the
> top and keep trying.
>
> In either case, once a successful startup is achieved, if an error occurs,
> weewx will restart from the top.
>
> On to your WLIP problems. The Davis serial protocol is very "chatty," with
> lots of state transitions. This makes it very difficult to run it over a
> WAN. It should work just fine with either static or dynamic IP assignments.
> However, it will be very sensitive to firewall settings.
>
> I do not own an IP logger, so it's very hard for me to debug them
> remotely.
>
> -tk
>
> On Sat, Jul 8, 2017 at 3:16 PM, Luc Heijst <[email protected]
> <javascript:>> wrote:
>
>> Hi Mike,
>>
>> I debugged the vantage driver for the ip-datalogger in March 2016 and
>> came across the same errors you have now.
>> I discovered the ip-datalogger needed other timings than the serial and
>> usb dataloggers.
>>
>> This is what I found in my old notes:
>>
>> # Serial delays (when using serial or USB):
>> command_delay = 0.2
>>
>> # TCP delays (when using the WeatherLinkIP):
>> command_delay = 1.0
>> tcp_send_delay = 0.2
>>
>> The default values of the current driver are:
>> command_delay = 0.5
>> tcp_send_delay = 0.5
>>
>> Maybe the command_delay time is too short for the ip-datalogger.
>> Default it is 0.5 s and it should be 1.0 s (according to my notes one
>> year ago)
>> You can try to increase the command_delay time by putting in the
>> [Vantage] section of weewx.conf:
>> command_delay = 1.0
>>
>> Maybe it helps.
>>
>> Luc
>>
>>
>> --
>> You received this message because you are subscribed to the Google Groups
>> "weewx-user" group.
>> To unsubscribe from this group and stop receiving emails from it, send an
>> email to [email protected] <javascript:>.
>> For more options, visit https://groups.google.com/d/optout.
>>
>
>
--
You received this message because you are subscribed to the Google Groups
"weewx-user" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
For more options, visit https://groups.google.com/d/optout.
