Chris, Is the inside temp higher than the outside temp? If it is, is the console light on? I found a 2-3 degree difference with console light on because it generates heat inside the console.
Dave-KB1PVH Sent from my Galaxy S7 On Mar 4, 2018 6:03 PM, <[email protected]> wrote: > I sprung for Vantage Pro 2 with aspiration. I have it hooked up to an RPi > with the serial logger. That part seems to work OK so far. > My question is about which wind cups (large or small) is included in the > standard kit these days? The Davis site is woefully lacking > in detail, and even the specs in the books are missing that one. The > other question is about calibration. I have the console and ISS > sitting in the same place, and the temp and humidity don't match (off a > couple of degrees and few percent). I found where to offset > the values in the console, but not sure if either are correct. Is this a > matter of averaging the values of a bunch of thermometers > and adjusting? I found two more temp/hum units, and I've adjusted the > console as needed, but does setting calibration change > the values that the data-logger sees? It doesn't seem like it, meaning I > need to duplicate the offsets in the weewx.conf. > > Thx, Chris > > -- > You received this message because you are subscribed to the Google Groups > "weewx-user" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > For more options, visit https://groups.google.com/d/optout. > -- You received this message because you are subscribed to the Google Groups "weewx-user" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
