Thanks Gary. Website is back to running as it was. Though i used "wee_device --set-interval=1" I need that immediacy. Happy.. Though I still have that fecking 15000mm/h rain rate ?? Clues../?
On Sun, Sep 30, 2018 at 5:58 PM gjr80 <[email protected]> wrote: > Ok, it looks like when you did the wee_device --clear you reset the > archive interval on your station to the default 30 minutes. When WeeWX > starts the archive interval is read from weewx.conf and the station (if > it supports this), if there is a discrepancy then the station archive > interval is used. In your case the answer is in the log (sorry did not read > this far when you first posted, that was a lot of log!): > > Sep 29 19:15:29 Weather-Station weewx[2068]: engine: The archive interval > in the configuration file (300) does not match the station hardware > interval (1800). > Sep 29 19:15:29 Weather-Station weewx[2068]: engine: Using archive > interval of 1800 seconds (specified by hardware)= > > This will explain the dotty plots as well, there is only one data point > being saved every 30 minutes. I suspect you want to change to a 5 minute > archive interval, to do this you will need to use wee_device again but > this time with the --set-interval action, something like: > > $ wee_device --set-interval=5 > > Note the interval is in minutes and also not you need to stop WeeWX before > doing this and then start again once set. Depending on your privileges you > may need to use sudo > > Gary > > On Sunday, 30 September 2018 14:25:05 UTC+10, Glenn F wrote: >> >> using the " sudo /etc/init.d/weewx start/stop " command. I had this set >> perfectly bugger it until I tried to remove the bad data :( which is still >> there and now my webpage is only logging updates every half hr even with >> the same weewx.conf file, before it would give me the exact time update >> with a page refresh per minute , and also the plots are dots rather than >> the line graph it was before.. Almost feel like giving up on this years >> data , only had it since JAN, and just starting over.. Would be hair >> pulling if I had some :P >> >> On Sat, Sep 29, 2018 at 8:34 PM gjr80 <[email protected]> wrote: >> >>> Exactly what command have you used to start/restart WeeWX? >>> >>> Gary >>> >>> -- >>> You received this message because you are subscribed to a topic in the >>> Google Groups "weewx-user" group. >>> To unsubscribe from this topic, visit >>> https://groups.google.com/d/topic/weewx-user/JWXQzbrLbms/unsubscribe. >>> To unsubscribe from this group and all its topics, send an email to >>> [email protected]. >>> For more options, visit https://groups.google.com/d/optout. >>> >> -- > You received this message because you are subscribed to a topic in the > Google Groups "weewx-user" group. > To unsubscribe from this topic, visit > https://groups.google.com/d/topic/weewx-user/JWXQzbrLbms/unsubscribe. > To unsubscribe from this group and all its topics, send an email to > [email protected]. > For more options, visit https://groups.google.com/d/optout. > -- You received this message because you are subscribed to the Google Groups "weewx-user" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
