Hmm I wonder if I should do this. I haven't seen my Acurite fail so I wonder if that's a PI 3B you are using.
On Thursday, December 27, 2018 at 5:20:42 PM UTC-8, Dallas Epperson wrote: > > I have fixed the issue, but leaving the thread here in case someone > googles the issue and it helps them. > > The issue was with the pi and how it handles USB. I followed this advice > from Jim Easterbrook > <https://github.com/jim-easterbrook/pywws/issues/38#issuecomment-396564038>to > keep that USB port from flipping between host and peripheral. > > sudo vi /boot/config.txt > add this line to the bottom: > dtoverlay=dwc2,dr_mode=host > and then reboot the pi. > > Cheers. > > On Thursday, December 27, 2018 at 7:42:24 PM UTC-5, Dallas Epperson wrote: >> >> I just installed weewx on a raspberry pi 3b+ running raspbian using apt. >> I have an AcuRite 01036M and the console connected to the pi via USB. On >> the AcuRite console, I have set USB mode to 3. >> >> I'm not certain the console is being properly recognized by the pi. When >> I issue a lsusb command, I see this: >> Bus 001 Device 004: ID 24c0:0003 >> Typically, I would expect to see the vendor and model number after that. >> >> Also, when I tail /var/log/syslog, I see these error messages: >> weewx[421]: acurite: Failed attempt 10 of 10 to get LOOP data: [Errno >> 110] Operation timed out >> >> Occasionally, Errno110 is replaced with >> [Errno 32] Pipe error >> >> Any ideas? >> > -- You received this message because you are subscribed to the Google Groups "weewx-user" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
