On Tuesday, January 29, 2019 at 2:18:54 AM UTC-5, Wifi75 wrote: > > Hello I have usb station WS1041 not start in weewx > see the pictuers below > > what ca I do? >
the product/vendor codes (0713:0818) for that station do not match anything recognized by any of the drivers i have seen it is definitely not a fine-offset usb model (1080/2080/3080), even though it appears to use the same instruments i think you will have to reverse engineer the usb protocol. if you have the software that came with the station, then the reverse engineering process is not too difficult. unless the manufacturer does something crazy, it typically takes a few hours to get to a point where you can talk to the hardware over USB, then a few days to decode the data, figure out the units, test the corner cases, etc. m -- You received this message because you are subscribed to the Google Groups "weewx-user" group. To unsubscribe from this group and stop receiving emails from it, send an email to weewx-user+unsubscr...@googlegroups.com. For more options, visit https://groups.google.com/d/optout.
