I checked with command vcgencmd_get_throttled if raspi has been under voltage or is under voltage it says everything is ok. Also I checked from dmesg, if there were any write errors or similar and there was no errors at all.
# /opt/vc/bin/vcgencmd get_throttled throttled=0x0 I guess I have to reinstall everything. On Sunday, March 3, 2019 at 2:04:10 AM UTC+2, Thomas Keffer wrote: > > Through the years, we've learned that these mysterious RPi failures are > almost always due to one of two things: > > 1. An inadequate power supply; or > 2. A failing SD card. > > I suspect the problem is #1. > > -tk > > On Sat, Mar 2, 2019 at 1:30 PM gizm0 <[email protected] <javascript:>> > wrote: > >> Thanks that explains the wee_device. Now wee_device command works 100%, >> but starting daemon is still failing and I cannot find any reason for that. >> The only reason which i can find is that in log it says "ee_device[1880]: >> fousb: found station on USB bus= device=". I don't understand why there is >> no BUS or Device defined. >> >> Anyways here is what wee_device command no displays when i change setting: >> ~# wee_device --set-interval=15 >> Using configuration file /etc/weewx/weewx.conf >> Using FineOffsetUSB driver version 1.9 (weewx.drivers.fousb) >> Interval is 15 >> Set interval to 15 minutes (y/n)? y >> Interval is now 15 >> >> >> On Saturday, March 2, 2019 at 10:57:18 PM UTC+2, Thomas Keffer wrote: >>> >>> It is >>> >>> * wee_device --set-interval=15* >>> >>> not >>> >>> * wee_device --set-interval 15* >>> >>> With the latter form, it's thinking that "15" is the name of your >>> configuration file. >>> >>> -tk >>> >>> On Sat, Mar 2, 2019 at 12:48 PM gizm0 <[email protected]> wrote: >>> >>>> Thank you for your reply. As you can see from the previous message >>>> where i attached the config the debug is set to 1. >>>> >>>> The system worked until 13:49 then it refused to start the service. So >>>> that's why there is working record on 13:40 timestamp. >>>> >>>> Weewx is running off site where it has worked with the same setup from >>>> last september. At least during last 1 month I have not touched anything. >>>> The only thing that system has done is upgrade packages automatically on >>>> 9.2.2019. >>>> >>>> Same hardware has been running the setup from last September. The only >>>> thing that I changed is that I bought 3months ago original Raspberry pi >>>> power supply ( >>>> https://cdon.fi/kodin-elektroniikka/raspberry-pi-3-micro-usb-power-supply-p40237610). >>>> >>>> Before that raspberry pi reported low voltage errors and that's why I >>>> bought better supply. >>>> >>>> Here is screenshot when i try to manually start the service, set device >>>> setting and check device status: >>>> >>>> [image: raspi2_weewx_02032019.jpg] >>>> >>>> >>>> On Saturday, March 2, 2019 at 9:35:06 PM UTC+2, vince wrote: >>>>> >>>>> On Saturday, March 2, 2019 at 11:04:26 AM UTC-8, gizm0 wrote: >>>>>> >>>>>> Sorry about that, but the weewx is not starting process so there is >>>>>> no activities after it has tried to start. Anyways here is the full log. >>>>>> Notice that weewx stopped to work around 13:49 and after that i have >>>>>> tried >>>>>> to manually start the service as you can see from the log. >>>>>> >>>>>> >>>>> Next time you do so, please set debug = 1 in your weewx.conf file so >>>>> we see more verbose logs. >>>>> >>>>> I grepped the file to show only lines with 'weewx' on them, and I >>>>> don't see any places where it actually stopped. Lots of startups, but no >>>>> stops. I also see a lot of places where it 'did' save records to the >>>>> database, at least briefly (most recently 13:40:35) so it worked at least >>>>> for a while, but it's impossible to know what you touched or when after >>>>> then. >>>>> >>>>> Just to eliminate the possibility, did you change any hardware ? Are >>>>> you powering things with a 'good' power supply ? That can mess up a >>>>> raspi >>>>> pretty consistently ? >>>>> >>>>> >>>>> -- >>>> You received this message because you are subscribed to the Google >>>> Groups "weewx-user" group. >>>> To unsubscribe from this group and stop receiving emails from it, send >>>> an email to [email protected]. >>>> For more options, visit https://groups.google.com/d/optout. >>>> >>> -- >> You received this message because you are subscribed to the Google Groups >> "weewx-user" group. >> To unsubscribe from this group and stop receiving emails from it, send an >> email to [email protected] <javascript:>. >> For more options, visit https://groups.google.com/d/optout. >> > -- You received this message because you are subscribed to the Google Groups "weewx-user" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
