On Saturday, 27 April 2019 15:58:57 UTC+2, Leon Shaner wrote:
>
> Hey, Ken,
>
> You've got two [Interceptor] sections, run together, using two different
> IP addresses.
>
> So you should end up with the following for the [Interceptor] section, but
> check that the IP is correct:
>
>
> ##############################################################################
>
> [Interceptor]
> # This section is for the network traffic interceptor driver.
>
> # The driver to use:
> driver = user.interceptor
>
> # Specify the hardware device to capture. Options include:
> # acurite-bridge - acurite internet bridge, smarthub, or access
> # observer - fine offset WH2600/HP1000/HP1003, ambient WS2902
> # lw30x - oregon scientific LW301/LW302
> # lacrosse-bridge - lacrosse GW1000U/C84612 internet bridge
> # wu-client - any hardware that uses the weather underground protocol
>
> driver = user.interceptor
> device_type = acurite-bridge
> mode = listen
> iface = ens3
> pcap_filter = src 192.168.2.10 and dst port 80
>
> [[sensor_map]]
> inTemp = temperature.8565.*
> inTemp = temperature.12520.*
> inTemp = temperature.2190.*
>
>
> ##############################################################################
>
>
> Regards,
> Leon
> --
> Leon Shaner :: Dearborn, Michigan (iPhone)
>
Thanks Leon,
However, it didn't like that:
Apr 27 15:39:52 hostname weewx[20326]: engine: Error while parsing
configuration file /etc/weewx/weewx.conf
Apr 27 15:39:52 hostname weewx[20326]: **** Reason: 'Duplicate keyword
name at line 79.'
Now I've got:
[Interceptor]
driver = user.interceptor
device_type = acurite-bridge
mode = listen
iface = ens3
pcap_filter = src 192.168.180.0/22 and dst port 80
[[sensor_map]]
inTemp = temperature.*.*
inHumidity = inHumidity.*.*
barometer = barometer.*.*
rxCheckPercent = rxCheckPercent.*.*
txBatteryStatus = txBatteryStatus.*.*
#inTemp = temperature.12387.* china room 1
#inTemp = temperature.15283.* china room 2
#inTemp = temperature.5422.* china room 3
#inTemp = temperature.2266.* china room 4
#inTemp = temperature.8565.* swiss room 1
#inTemp = temperature.12520.* swiss room 2
#inTemp = temperature.2190.* swiss room 3
But, looking at the my webpage, I'm only getting one value for inside
temperature, so I'm guessing that I need to define each sensor with a
different name other than inTemp
--
You received this message because you are subscribed to the Google Groups
"weewx-user" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
For more options, visit https://groups.google.com/d/optout.
