Hello, Jens Unfortunately, no, the StdQC service can only detect out of bounds, not big changes or spikes. You would have to modify it, or write your own service to do that.
On Tue, Apr 7, 2020 at 6:28 AM 'Jens-Jørgen Kjærgaard' via weewx-user < [email protected]> wrote: > I have been a user for many years, and the software is usually running > smoothly. > Some years back, I added the temperature of my lake as extraTemp1 - also > fine. > Now, I also monitor the water level, by means of ultrasound, using the > HC-SR04. I have added this as extraTemp2, and don't min it shows as C in > the graphs. > I have a little problem with that sensor, though. Sometimes it will show a > far off reading, which has to be ignored, ie if it is more than 2 cm off > the previous reading. > But I can't figure out how to do that. Is there a way to store the > previous reading and use that (temporarily) for comparison? Or the average > of the readings up to that point? > > Jens-Jørgen Kjærgaard > Tuenvej 818 > 9870 Sindal > Denmark > +45 21204417 > www.jensjk.dk > > -- > You received this message because you are subscribed to the Google Groups > "weewx-user" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To view this discussion on the web visit > https://groups.google.com/d/msgid/weewx-user/CAJPduSSUyb7_XSAPyXs-dSJkbfVzsZUmDJVpbgamFVw%3DkL00hg%40mail.gmail.com > <https://groups.google.com/d/msgid/weewx-user/CAJPduSSUyb7_XSAPyXs-dSJkbfVzsZUmDJVpbgamFVw%3DkL00hg%40mail.gmail.com?utm_medium=email&utm_source=footer> > . > -- You received this message because you are subscribed to the Google Groups "weewx-user" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/weewx-user/CAPq0zEDeioBFFEm7ZRVZu7yKbwH0Xcsnv5uf%3DJn4PwrpCNhdGw%40mail.gmail.com.
