you probably have, but it doesn’t hurt reminding: before even considering weewx, make sure you repeated *all* the installation steps for rtl433, not just dropped stuff in, and from a blank slate not from an earlier attempt. i have had to do this several times (migrating hosts), and i have made this mistake with rtl433 twice - leaving out a step, doesn’t work, continue build instead of wiping it, still won’t work
> On 12 May 2021, at 1:06 pm, 'dvdhns' via weewx-user > <[email protected]> wrote: > > Not much luck. > The symlinks sorta worked - but then I was getting errors that showed the RTL > was already being used, it was like it was calling it twice. > I tried putting the full path in the command line in the SDR section of the > weewx.conf. That made weewx produce no errors, but nothing was being > collected. Yet, when I set debug in weewx.conf >0 it looked like it was > seeing data, but not writing it. > Totally confused, at this point. I started from scratch, installed weewx > using Python3 and had same results. > I had this hardware setup working for 11 months - just burned out my microSD > card on the RPi. If only I realized it would be this hard to get things > working again. -- You received this message because you are subscribed to the Google Groups "weewx-user" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/weewx-user/F49062E3-80CF-460C-91A8-CD0F6BA35508%40gmail.com.
