Just in case anyone runs into this, turns out you need to reset the data logger. Below are instructions from Davis:
- Disconnect the USB Datalogger from the USB cable - Remove all power from the console that I assume the USB datalogger is installed in (remove all batteries and AC power) - Remove the USB datalogger and check for bent pins and make sure pins are straight in the console - *Leave without power for 1 full minute* - After 1 full minute, slowly lineup and install the USB datalogger, push VERY VERY hard to make sure it is installed very snug - Connect the USB cable to the USB Datalogger - *LEAVE BATTERIES OUT* - Connect console with AC power - Once you see, “Welcome to Davis………” message, hold down the <DONE> button on the console 3 seconds to bring it back to the home screen After you do that restart WeeWx and it should be back up and running. On Wednesday, July 14, 2021 at 6:17:04 PM UTC-7 [email protected] wrote: > > Yeah no issues with it picking up data from the sensors > > On Wednesday, July 14, 2021 at 3:21:10 PM UTC-7 vince wrote: > >> Does the console recognize your Vue sensors ok ? >> >> On Wednesday, July 14, 2021 at 11:38:48 AM UTC-7 [email protected] >> wrote: >> >>> So I switched out my console for my Davis Vantage Vue because the old >>> one had the signal fail. Now with the new one WeeWx doesn’t seem to >>> recognize the hardware. >>> >>> ./EW5321/bin/wee_device --info >>> Using configuration file /home/pi/EW5321/weewx.conf >>> Using Vantage driver version 3.2.1 (weewx.drivers.vantage)Traceback >>> (most recent call last): >>> File "./EW5321/bin/wee_device", line 78, in <module> >>> main() >>> File "./EW5321/bin/wee_device", line 74, in main >>> device.configure(config_dict) >>> File "/home/pi/EW5321/bin/weewx/drivers/__init__.py", line 67, in >>> configure >>> self.do_options(options, parser, config_dict, not options.noprompt) >>> File "/home/pi/EW5321/bin/weewx/drivers/vantage.py", line 2056, in >>> do_options >>> station = Vantage(**config_dict[DRIVER_NAME]) >>> File "/home/pi/EW5321/bin/weewx/drivers/vantage.py", line 515, in >>> __init__ >>> self._setup() >>> File "/home/pi/EW5321/bin/weewx/drivers/vantage.py", line 1321, in >>> _setup >>> self.hardware_type = self._determine_hardware() >>> File "/home/pi/EW5321/bin/weewx/drivers/vantage.py", line 1312, in >>> _determine_hardware >>> raise weewx.WeeWxIOError("Unable to read hardware type") >>> weewx.WeeWxIOError: Unable to read hardware type >>> >> -- You received this message because you are subscribed to the Google Groups "weewx-user" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/weewx-user/8e0e78cd-5273-4762-8442-4526823fba2fn%40googlegroups.com.
