Hello,
I have set up a VEVOR 7-in-1 Wi-Fi Weather Station and would like to connect it to WeeWX. I believe that the WeeWX-interceptor could be a solution, or at least worth trying! I installed WeeWX and the interceptor without any issues. Before attempting to connect my station, I want to verify the data being sent to wunderground.com, where my station transmits its data, or at least check if I can see them. My configuration is as follows: - The weather station is connected via Wi-Fi to a Devolo Wi-Fi network (using Powerline Communication, PLC). - The reception is done by the Devolo LAN (through PLC). - The Devolo LAN is connected to my router. >From my computer, which is also connected through the Devolo Wi-Fi, I determined the station's IP address using ZeNMAP (confirmed by powering off the station: when I ping the IP, I get no response from the station). Using Wireshark, I monitor the flow on the Wi-Fi (wlan0), and there is a lot of traffic. I applied a filter for the station's IP address, but then I observe nothing—no traffic!? I also scanned the LAN, but still no additional data. Next, I placed an Ethernet Network Tap between the router and the Devolo LAN. I connected a Raspberry Pi to this tap and monitored the LAN activity using tcpdump, but again, there was nothing related to my station. I'm struggling to understand why! The station's data is visible on the Wunderground site, updated every minute. It's not a pigeon delivering the data... So, my question is: what am I doing wrong? -- You received this message because you are subscribed to the Google Groups "weewx-user" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion visit https://groups.google.com/d/msgid/weewx-user/a43fc580-7fc0-4bd2-b71a-e9926ae4740bn%40googlegroups.com.
