Hi!
Just create different icons for each service and assign service names to
icons.
All these icons should depend on "main" server.
Of course you�ll get more that one ping for each resource with services.
Edgars.
|---------+------------------------------------->
| | "Amihay Bareket" |
| | <[EMAIL PROTECTED]> |
| | Sent by: |
| | [EMAIL PROTECTED]|
| | pswitch.com |
| | |
| | |
| | 2002.09.12 16:55 |
| | Please respond to |
| | WhatsUp_Forum |
| | |
|---------+------------------------------------->
>------------------------------------------------------------------------------------------------------------------------------|
|
|
| To: <[EMAIL PROTECTED]>
|
| cc:
|
| Subject: [WhatsUp Forum] Is there a way to receive UP alerts for each
individual service? |
>------------------------------------------------------------------------------------------------------------------------------|
I'm running WUG 7.0x (Currently upgraded to 7.04) on Windows 2000
server, SP3.
There's seems to be a problem with the up alerts -
Whenever a services goes done, an alerts goes out correctly (I'm
currently using Email & Syslog). The problem occurs when the service
goes back up. I then receive a message of all the services that are on
that host, and not just about the one that failed earlier. This presents
a problem in case there's more then one failed service on a host, and I
want to be notified separately for each service that goes back up.
I've tried configuring the alerts both with the to possible options -
"Send UP alert after the device and all services are up" "Send
individual UP alerts for the device and each service that comes up"
The message string I'm using is -
%T %h (%a) %Y %v %u at %d %t
%T - Device type (for example - server)
%h - Device name (For Example - exchange)
%a - Device IP Address (For example - 10.20.21.31)
%Y - Name of UP services - this is sent on the up notification
(For example - "NT Disk space - partition 1")
%v - Name of DOWN services - this is sent on the down
notification
%u - Service/Host status (UP or DOWN for device, SVCUP or
SVCDOWN for service)
%d - date when the message was sent
%t - time when the message was sent
I've tried using different variables, but they all produced the same
result - a list of all UP services on the host.
Can any one think of a way to send UP alerts that will specify only the
name of the service that came back up?
Amihai Bareket
Senior System Engineer & Consultant
Email: [EMAIL PROTECTED]
Please visit http://www.ipswitch.com/support/mailing-lists.html
to be removed from this list.
An Archive of this list is available at:
http://www.mail-archive.com/whatsup_forum%40list.ipswitch.com/
Please visit http://www.ipswitch.com/support/mailing-lists.html
to be removed from this list.
An Archive of this list is available at:
http://www.mail-archive.com/whatsup_forum%40list.ipswitch.com/
