Can you manage the Transceiver via IP? if not you can't tell if it is the transceiver or the IP Device.
Doug Zemke Network Services State of Missouri DMH 573-751-9112 CONFIDENTIALITY NOTICE: This e-mail communication and any attachments may contain confidential and privileged information for the use of the designated recipients named above. The designated recipients are prohibited from redisclosing this information to any other party without authorization and are required to destroy the information after its stated need has been fulfilled. If you are not the intended recipient, you are hereby notified that you have received this communication in error and that any review, disclosure, dissemination, distribution or copying of it or its contents is prohibited by federal or state law. If you have received this communication in error, please notify me immediately by telephone at 573-751-9112, and destroy all copies of this communication and any attachments. -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] Sent: Monday, February 10, 2003 2:39 PM To: [EMAIL PROTECTED] Subject: [WhatsUp Forum] Pin-Point the failure Is there any way to determine which piece failed in wug, here is the set-up Cisco switch--------CAT5-----Transceiver--------Fiber--------Transceiver------CAT5 --------IP Device Tim Fulton Systems Supervisor Voice: (614) 278-6596 Mobile (614) 778-2430 Fax (614) 278-3218 Email: [EMAIL PROTECTED] Big Lots! 300 Phillipi Road Columbus, Ohio 43228 Please visit http://www.ipswitch.com/support/mailing-lists.html to be removed from this list. An Archive of this list is available at: http://www.mail-archive.com/whatsup_forum%40list.ipswitch.com/ Please visit http://www.ipswitch.com/support/mailing-lists.html to be removed from this list. An Archive of this list is available at: http://www.mail-archive.com/whatsup_forum%40list.ipswitch.com/
