Hello: I get traps like this from my Cisco routers when frame-relay links go up or down: Trap(frameRelay-6.1) frCircuitIfIndex.1.112=1 frCircuitDlci.1.112=112 frCircuitState.1.112=2. This works OK, but since I forward these traps to my phone, it would be great to have the most important information (frCircuitState.1.112=2, the 2 signifying that the link is up) show up in the first few lines of the message. It would also be nice for my helpdesk folks if I could have it identify the link by name, rather than just DLCI. From the WUG side, I have tried to set up alerts based on the whole trap string I get, but it will only listen for the actual trap (Trap(frameRelay-6.1)), which makes it impossible for WUG to tell the difference between different circuits. So here are my questions: Can I do what I have described in WUG (make different alerts that conatin different DLCI values, etc)? Also, can I get clever with my MIB definitions to convert frCircuitState.1.112=2 into, say "Location1Up"?
Thanks, Dan Brown Please visit http://www.ipswitch.com/support/mailing-lists.html to be removed from this list. An Archive of this list is available at: http://www.mail-archive.com/whatsup_forum%40list.ipswitch.com/
