Thanks for the info Bryan. We initially started out on port 80 and had the same results, we changed the port of course for security reasons and suggestions from other users. We will try and narrow it down until it works
Thanks again. Mark A. Hunsaker Systems Administrator Town of Flower Mound 972.874.6053 voice 972.874.6452 fax [EMAIL PROTECTED] -----Original Message----- From: Bryan Harrell [mailto:[EMAIL PROTECTED] Sent: Wednesday, March 03, 2004 9:51 AM To: [EMAIL PROTECTED] Subject: RE: [WhatsUp Forum] Number of devices concern Mark, Your source port will change with every initiated browser session. The authentication command should be sent back to you on your source port from WUG's Port-80 as an authentication challenge which windows will then pop up. Because you will never know what the source port is until it's opened for communications, I suspect using a port scanner will not help in this instance. As much as I hate to suggest this, it may be that you might have to open up the NetBIOS (Ports 137-139) and then narrow it down from there but this should not be required if it does work. Also check with your firewall manufacturer to see what they can suggest since it appears to be dropping the communications. As a testing step only, try setting the WUG WEB interface back to Port 80 and see if it makes any difference accessing it thru the firewall. If it does, then it might be you'll have to open up Port 80- as well as what ever your upper level port you config the WEB interface to use. Good luck hunting this one down... ------------------------------------------------------------ Bryan Harrell, SPII Network Transport & Administration - Tallahassee Fla. Dept of Revenue (850)-921-0700 S/C 291-0700 ------------------------------------------------------------ >>> [EMAIL PROTECTED] 03/02/2004 11:35:24 AM >>> Hello all, Once again I am asking for help from all the knowing public: I have set up my WUG server and have the Web Server running on a port other than the standard 80. I have created a conduit portal through my firewall and need to be able to access the WUG Web Server pages from anywhere. I cannot get the access/login screen to appear through the firewall conduit unless I open every port. Can anyone tell me what ports besides the one the Web Server is set to run on are in use. I have port scanned the system and only hit on four active ports and when opening them I still cannot get to the access/login screen. Thanks in advance. Mark A. Hunsaker Systems Administrator Town of Flower Mound 972.874.6053 voice 972.874.6452 fax [EMAIL PROTECTED] <mailto:[EMAIL PROTECTED]> Please visit http://www.ipswitch.com/support/mailing-lists.html to be removed from this list. An Archive of this list is available at: http://www.mail-archive.com/whatsup_forum%40list.ipswitch.com/ Please visit http://www.ipswitch.com/support/mailing-lists.html to be removed from this list. An Archive of this list is available at: http://www.mail-archive.com/whatsup_forum%40list.ipswitch.com/
