Sorry Steve,
I wasn't clear on my original question.
Yes, I am looking for the PIX config to allow WUG to monitor the pix on its
internal interface.
I have the MIB's compiled in WUG. Most of what I monitor are Cisco routers
and switches. Bottom line, I am just going to monitor the ports on the PIX
501, if a port disappears, connectivity has been lost. The 501 has an
integrated 4 port switch. (fa1-4) and the wan connection is fa0. So I
basically just wanted to monitor fa0 as being up or down.
Anyway short answer is: I am asking for help on how to configure the PIX to
allow WUG to monitor SNMP on the PIX.
--bruce
-----Original Message-----
From: Steve C Busby [mailto:[EMAIL PROTECTED]
Sent: Monday, August 01, 2005 5:24 PM
To: [email protected]
Cc: '[email protected]';
[EMAIL PROTECTED]
Subject: Re: [WhatsUp Forum] Monitoring a PIX 501
Hi Bruce,
Are you looking for the configuration needed on your Whatsup Server to
monitor the Pix via SNMP? If so, then wouldn't the IP address and SNMP RO
community string provide that?
Or are you looking for what changes need to be made on the PIX to allow it
to be monitored/accessed via SNMP?
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Thanks,
Steve Busby
Information Technology Services
University of Nebraska Medical Center
985030 Nebraska Medical Center
[EMAIL PROTECTED]
402.559.9621
If Linux doesn't have the solution, you have the wrong problem.
***************University of Nebraska Medical Center E-mail Confidentiality
Disclaimer ***************
The information in this e-mail is privileged and confidential, intended
only for the use of the addressee(s) above.
Any unauthorized use or disclosure of this information is prohibited. If
you have received this e-mail by mistake
please delete it and immediately contact the sender.
"Meyer, Bruce"
<[EMAIL PROTECTED]
sc.net> To
Sent by: "'[email protected]'"
WhatsUp_Forum-own <[email protected]>
[EMAIL PROTECTED] cc
com
Subject
[WhatsUp Forum] Monitoring a PIX
08/01/05 02:48 PM 501
Please respond to
[EMAIL PROTECTED]
t.ipswitch.com
Does anyone have a working config for SNMP monitoring of a PIX?
The scenario is:
We have a few remote locations that we can't hit with our traditional
methods, so we use Cable and a PIX, and IP over RF and a PIX.
Both are public lines, with a nailed VPN tunnel.
I just want to monitor the PIX for snmp.
Thanks for any help.
-----------------------
Bruce D. Meyer, CCNA, MCSE
Network Analyst
City of Columbia
Please visit http://www.ipswitch.com/support/mailing-lists.html
to be removed from this list.
An Archive of this list is available at:
http://www.mail-archive.com/whatsup_forum%40list.ipswitch.com/
Please visit http://www.ipswitch.com/support/mailing-lists.html
to be removed from this list.
An Archive of this list is available at:
http://www.mail-archive.com/whatsup_forum%40list.ipswitch.com/
Please visit http://www.ipswitch.com/support/mailing-lists.html
to be removed from this list.
An Archive of this list is available at:
http://www.mail-archive.com/whatsup_forum%40list.ipswitch.com/
