Bruce,
I am
not sure, but I believe doing a Get All Subitems on 1.3.6.1.4.1.9600.1.1.5.1.5
wuold yield the 5 lines of values in your case. The 5 value is going to be much
longer value string, ie: cpuPercentProcessorTime.6.95.84.111.116.97.108. I
believe this value would the same as the average for all.
Mark Singh
Ipswitch, Inc.
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]On Behalf Of Meyer, Bruce
Sent: Friday, September 23, 2005 9:36 AM
To: [email protected]
Subject: [WhatsUp Forum] Could someone review my server CPU Usage Service/Monitor config a nd recommend an improvement?I am trying to get a handle on CPU usage on a few servers. I am using this string:1.3.6.1.4.1.9600.1.1.5.1.5.1.481.3.6.1.4.1.9600.1.1.5.1.5.1.491.3.6.1.4.1.9600.1.1.5.1.5.1.501.3.6.1.4.1.9600.1.1.5.1.5.1.51To see each CPU in the net tools (SNMP)I created a single Monitor/Service and set it to Range of Values with a low value of 0 and a high value of 90. and test fails when exceeded 10 consecutive polls.The Polls are 1 minute apart.I figure if I get over 10 minutes straight of 90% CPU usage across 4 CPU's it would be good to know about it.I currently only check for one CPU. Is their a way to check all the cpu's average usage from one Monitor/Service ? Or do I need to create four separate ones? I don't think four separate ones would make much sense.Any help or advise is appreciated.--Bruce D. Meyer
