Thanks Howard,
I will give that a shot.
--Bruce
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] On Behalf Of Howard Jones
Sent: Wednesday, October 12, 2005 4:35 AM
To: [email protected]
Subject: Re: [WhatsUp Forum] Scripting in Whats Up Gold
Meyer, Bruce wrote:
> Am I correct in assuming that your 'testconnection.asp is a homegrown
asp?
> Can I just replace that with a:
>
> Send=GET www.somewebpage.com HTTP/1.0\r\n
>
> I don't know what your testconnection.asp does.
>
not quite - you'd replace it with
Send=GET / HTTP/1.0\r\nHost: www.somewebpage.com\r\n\r\n Expect=~Connection
OK
for that. The part after the GET is the page within the site. If the server
uses HTTP virtual hosts, then you must include the Host: section.
Finally, there should be two sets of \r\n\r\n at the end, otherwise it isn't
a valid HTTP request.
testconnection.asp is a page our customer wrote that simply connects to an
off-site database, and then reports on whether it did or didn't connect.
Something like
<%
set conn=Server.CreateObject("ADODB.Connection")
conn.Open "OurDSN"
If Err.Number = 0 then
response.write "Connection OK"
end if
conn.close
%>
I think. Wow, it's been a while since I wrote any VBScript! :-)
Best Regards,
Howard
Please visit http://www.ipswitch.com/support/mailing-lists.html
to be removed from this list.
An Archive of this list is available at:
http://www.mail-archive.com/whatsup_forum%40list.ipswitch.com/
Please visit http://www.ipswitch.com/support/mailing-lists.html
to be removed from this list.
An Archive of this list is available at:
http://www.mail-archive.com/whatsup_forum%40list.ipswitch.com/
